Abstract:Co-base ODS alloys, strengthened by nanosized oxide dispersion and gamma' precipitates, were prepared by mechanical alloying. Hot compression tests were performed in the temperature range of 25-970 degrees C with the strain rate varying from 0.0001 to 0.01 s(-1). The influence of deformation parameters and Y2O3 content on the flow behavior and the microstructure of compressive specimens were investigated. It was observed that Co-base ODS alloys had exhibited the homogeneous distribution of ultrafine gamma' precipitates (0.26 mu m), nanosized oxide particle (12.5 nm), and small grains (1.1 mu m). The enhanced flow stress at low temperatures and high strain rates was attributed to the rapid multiplication of dislocations due to the pining effect of oxide dispersion, gamma' precipitates, and fine grains. The peak stress had decreased with increasing the deformation temperature as well as by decreasing the strain rate. The obvious improvement in flow stress was acquired by increasing the Y2O3 contents. Grain boundary sliding and porosity growth had been considered to be the main softening mechanisms during the hot deformation at elevated temperature. Moreover, It was found that the flow softening could be accelerated by decreasing the strain rate. The activation energy had increased with increasing temperature, but decreased with decreasing strain rate. (C) 2011 Elsevier B. V. All rights reserved.

Microstructural Characterization of Co-Based ODS Alloys

Microstructural Formation in Novel Co-Base ODS Alloys Produced by Mechanical Alloying

Characteristics of Complex Oxides in Co Based ODS Alloys

Microstructures and Mechanical Properties of a L12-structured Precipitation Strengthened Co-based Superalloy

Mechanical alloying of ODS tungsten heavy alloys and microstructure development of intermetallic compounds

Effect of Microstructure Evolution on Micro/Nano‐Mechanical Property of Fe–Co–Ni Ternary Alloys Solidified under Microgravity Condition

Hot Deformation Behavior of Co-base ODS Alloys

Microstructures and Mechanical Properties of a L1 2 -structured precipitation Strengthened Co-based Superalloy

Basic Characterization of Oxide Dispersion Strengthened Fine-Grained Tungsten Based Materials Fabricated by Mechanical Alloying and Spark Plasma Sintering

Microstructural Evolution of a Newly Developed γ' Strengthened Co-base Superalloy

Microstructure and mechanical properties of FeCoNiCr high-entropy alloy strengthened by nano-Y 2 O 3 dispersion

Microstructures and Mechanical Properties of a Cu-bearing ODS Steel Fabricated by Mechanical Alloying and Hot Extrusion

Microstructural Evolution in a New Fe Based ODS Alloy Processed by Mechanical Alloying

Microstructure Characterization and Mechanical Properties of Al Alloyed 9cr ODS Steels with Different Al Contents

Microstructure Evolution and Mechanical Properties of ODS FeCrAl Alloys Fabricated by an Internal Oxidation Process

Oxide-stabilized microstructure of severe plastically deformed CuCo alloys

Microstructure, Phase Stability and Element Partitioning of Γ-Γ′ Co-9Al-9W-2X Alloys in Different Annealing Conditions

Achieving ultrahigh strength in oxide-dispersion-strengthened CoCrNi alloy via in situ formation of coherent Y-Ti-O nanoprecipitates

Microstructural Modelling Solution for Complex Co Based Alloys and Coatings

Influence Mechanism of Ductility and Introduction of Nano-Oxides in Nickel-Base ODS Superalloys

Formation and Microstructural Evolution of Ferritic ODS Steel Powders during Mechanical Alloying