Abstract:Oxide dispersion strengthened (ODS) steels are promising materials for structural applications in the IV Generation of fission, and fusion reactors. The ODS steel prepared by low-energy mechanical alloying (LEMA) followed by hot extrusion (HE) has been subjected to tensile tests at increasing temperature up to 700 °C. The fracture surfaces have been investigated through scanning electron microscopy (SEM) observations and X-ray photoelectron spectroscopy (XPS) analyses in order to understand the ductility changes vs. temperature. Owing to microstructural heterogeneity a mixed mode of fracture (ductile plus brittle) occurs at every test temperature. Both fracture modes depend on the interaction of dislocations with particles and ductility variations with temperature have been discussed by considering the mobility of dislocations and their capability to unlock from particles. Ductile fracture occurs in the zones where nano-precipitates are homogeneously distributed while the grains close to nano-precipitate clusters exhibit cleavage rupture. XPS revealed a relation between brittle fracture and Cr segregation since the Cr-rich zones represent a preferred path for cleavage cracks. The decrease of ductility around 400 °C has been explained on the basis of internal friction measurements showing a re-arrangement of dislocation structures. The results indicate that further improvement of the mechanical properties of ODS steels can be achieved through a more homogeneous distribution of fine particles.

Influence Mechanism of Ductility and Introduction of Nano-Oxides in Nickel-Base ODS Superalloys

Investigation on Different Additions As Candidates for Nano-Oxide Particles in Nickel-Based ODS Superalloys

Flow Behaviors and Microstructural Evolutions of Nickel-Based ODS Superalloys During Hot Deformation

Optimizing the Thermomechanical Process of Nickel-Based ODS Superalloys by an Efficient Method

Effect of Y2O3 content and sintering temperature on mechanical properties of ODS nickel-based superalloy

Bimodal-grained high-strength nickel-base ODS alloy fabricated by mechanical alloying and hot extrusion

Effect of Heat Treatment on Microstructure and Mechanical Properties of ODS Nickel-Based Superalloy Via Strengthening Mechanism

High temperature oxidation behavior of low density MA/ODS nickel-based superalloy

Oxide Dispersion Strengthening Nickel-Based Superalloy Prepared by Supersolidus Liquid Phase Sintering

Long-term Oxidation Behavior and Mechanism of DD6 Ni-based Single Crystal Superalloy at 1050 °C and 1100 °C in Air

Intermediate Temperature Brittleness and Directional Coarsening Behavior of Nickel-Based Single-Crystal Superalloy DD6

Process Optimization and Mechanical Properties of Oxide Dispersion Strengthened Nickel-Based Superalloy by Selective Laser Melting

Effect of Process Control Agent on Microstructures and High-Temperature Oxidation Behavior of a Nickel-Based ODS Alloy

Mechanical alloying of ODS tungsten heavy alloys and microstructure development of intermetallic compounds

Influence of Microstructural and Loading Direction on the Ductility and Anisotropy of Ni-based Superalloys

Influence of temperature on ductility of nano-ODS steel prepared by low-energy mechanical alloying

Microstructures and Mechanical Properties of a Cu-bearing ODS Steel Fabricated by Mechanical Alloying and Hot Extrusion

Microstructure Evolution and Mechanical Properties of ODS FeCrAl Alloys Fabricated by an Internal Oxidation Process

Effects of Milling Time on the Tensile Properties of Nickel-Based Oxide Dispersion Strengthened Alloy

The Role of Nanoscale Heterogeneous Structure in Simultaneously Enhancing Strength and Ductility of High-Oxygen Ti–6Al–4V Alloy

Strength-hardness correlations of thermal-exposed oxide dispersion strengthened nickel-based superalloy with different grain size distributions