Abstract:Ten-kilovolt SiC MOSFETs are currently under development by a number of organizations in the United States, with the aim of enabling their applications in high-voltage high-frequency power conversions. The aim of this paper is to obtain the key device characteristics of SiC MOSFETs so that their realistic application prospect can be provided. In particular, the emphasis is on obtaining their losses in various operation conditions from the extensive characterization study and a proposed behavioral SPICE model. Using the validated MOSFET SPICE model, a 20-kHz 370-W dc/dc boost converter based on a 10-kV 4H-SiC DMOSFET and diodes is designed and experimentally demonstrated. In the steady state of the boost converter, the total power loss in the 15.45-$\hbox{mm}^{2}$ SiC MOSFET is 23.6 W for the input power of 428 W. The characterization study of the experimental SiC MOSFET and the experiment of the SiC MOSFET-based boost converter indicate that the turn-on losses of SiC MOSFETs are the dominant factors in determining their maximum operation frequency in hard-switched circuits with conventional thermal management. Replacing a 10-kV SiC PiN diode with a 10-kV SiC JBS diode as a boost diode and using a small external gate resistor, the turn-on loss of the SiC MOSFET can be reduced, and the 10-kV 5-A SiC MOSFET-based boost converter is predicted to be capable of a 20-kHz operation with a 5-kV dc output voltage and a 1.25-kW output power by the PSpice simulation with the MOSFET model. The low losses and fast switching speed of 10-kV SiC MOSFETs shown in the characterization study and the preliminary demonstration of the boost converter make them attractive in high-frequency high-voltage power-conversion applications.

400Khz, 300W SiC BJT Based High Power Density PFC Converter

Performance Evaluation of SiC MOSFET/BJT/Schottky Diode in A 1mhz Single Phase PFC

High efficiency power factor correction power supply based on SiC device

An Extremely High Efficient Three-Level Active Neutral-Point-Clamped Converter Comprising SiC and Si Hybrid Power Stages

Sic Mosfet Zero-Voltage-Switching Svm Controlled Three-Phase Grid Inverter

An SiC MOSFET & Si Diode Hybrid Three-Phase High-Power Three-level Rectifier

3.38 Mhz Operation of 1.2kv SiC MOSFET with Integrated Ultra-Fast Gate Drive

Silicon carbide-based digitally controlled zero voltage switching dual-phase interleaved totem-pole PFC rectifier operating at high frequency

Efficiency improvement of a SiC-MOSFET 500 kHz ZVS inverter

A 100kW Forced-Air-Cooled SiC MOSFET Converter Achieving a Power Density of 1.657kW/L and an Efficiency over 98.5%

A High Efficiency Two-Stage ZVS AC/DC Converter with All SiC MOSFET

Design of Ac/dc Converter for Bidirectional On-Board Battery Charger with Minimizing the Amount of SiC MOSFET

Design and Application of High-Voltage SiC JFET and Its Power Modules

Design and Implementation of Forced Air-cooled, 140kHz, 20kW SiC MOSFET based Vienna PFC

High-voltage full-SiC power module: Device fabrication, testing and high frequency application in kW-level converter

Fabrication and testing of 3500V/15A SiC JFET based power module for high-voltage, high-frequency applications

Optimal Design of SiC MOSFETs for 20kw DCDC Converter

Design and Application of A 1200v Ultra-Fast Integrated Silicon Carbide Mosfet Module

A High-Frequency Dynamically Coordinated Hybrid Si/SiC Interleaved CCM Totem-Pole Bridgeless PFC Converter

Design and Loss Analysis of the High Frequency Pfc Converter

Characterization, Modeling, and Application of 10-kV SiC MOSFET