Abstract:Due to their extremely high energy demand, data centers are directly supplied from a medium-voltage (MV) grid. However, a significant part of this energy is dissipated in the power supply chain since the MV is reduced step-by-step through multiple power conversion stages down to the chip-voltage level. In order to increase the efficiency of the power supply chain, the number of conversion stages must be substantially reduced. In this context, solid-state transformers (SSTs) are considered as a possible solution, as they could directly interface the MV AC grid to a 400 V DC bus, whereby server racks with a power consumption of several tens of kilowatts could be directly supplied from an individual SST. With a focus on the lowest system complexity, the SST, ideally, should be built as simple two-stage system consisting of an MV AC/DC power factor correction (PFC) rectifier stage followed by an isolated DC/DC converter. Accordingly, this paper focuses on the design and realization of a 25 kW, 3.8 kV single-phase AC to 7 kV DC PFC rectifier unit based on the 10 kV SiC MOSFETs. By simply adding an $LC$ circuit between the switch nodes of the well-known full-bridge-based pulse width modulated AC/DC rectifier, the integrated triangular current-mode concept is implemented, which only internally superimposes a large triangular current ripple on the AC mains current and, therefore, enables zero-voltage switching over the entire AC mains period. Special attention is paid to the realization of the MV inductors and their electrical insulation, the AC-input $LCL$ filter to limit electromagnetic interference emissions, and the challenges arising due to cable resonances when connecting the SST to the MV grid via an MV cable. Despite the large insulation distances required for MV, the realized 25 kW MV PFC rectifier achieves an unprecedented power density of 3.28 kW/L (54 W/ $\mathrm {in}^{3}$ ) and a full-load efficiency of 99.1%, determined using a calorimetric measurement setup, which is discussed in detail in the Appendix.

Design and Implementation of Forced Air-cooled, 140kHz, 20kW SiC MOSFET based Vienna PFC

Hybrid SiC-Si DC–AC Topology: SHEPWM Si-IGBT Master Unit Handling High Power Integrated with Partial-Power SiC-MOSFET Slave Unit Improving Performance

High efficiency power factor correction power supply based on SiC device

Performance Evaluation of SiC MOSFET/BJT/Schottky Diode in A 1mhz Single Phase PFC

An SiC MOSFET & Si Diode Hybrid Three-Phase High-Power Three-level Rectifier

Efficiency improvement of a SiC-MOSFET 500 kHz ZVS inverter

400Khz, 300W SiC BJT Based High Power Density PFC Converter

Three-Phase Buck Rectifier Based on SiC MOSFETs Used in Power Factor Correction

A Phase-Leg Full SiC Power Module Used in Vienna Rectifiers

A High Efficiency Two-Stage ZVS AC/DC Converter with All SiC MOSFET

Simulation on SiC Based Three Phase Boost Power Factor Correction Rectifier Using MATLAB PLECS Model and Its Numerical Analysis Verification

Sic Mosfet Zero-Voltage-Switching Svm Controlled Three-Phase Grid Inverter

A 100kW Forced-Air-Cooled SiC MOSFET Converter Achieving a Power Density of 1.657kW/L and an Efficiency over 98.5%

Non-Magnetic Resonant-Type High-Frequency High-Voltage Power Conversion with Silicon Carbide Power Semiconductor Devices

A novel single-phase active-clamped ZVT-PWM PFC converter

Design and evaluation of press-pack SiC MOSFET

99.2%Efficiency ZVS Single-phase PFC Rectifier with SiC MOSFET

Characteristics of SiC MOSFET and its application in a phase-shift full-bridge converter

Digitized Feedforward Compensation Method for High Power Density Three-Phase VIENNA PFC Converter

A 1200-V, 60-A SiC MOSFET Multichip Phase-Leg Module for High-Temperature, High-Frequency Applications

99.1% Efficient 10 kV SiC-Based Medium-Voltage ZVS Bidirectional Single-Phase PFC AC/DC Stage