Abstract:Due to their extremely high energy demand, data centers are directly supplied from a medium-voltage (MV) grid. However, a significant part of this energy is dissipated in the power supply chain since the MV is reduced step-by-step through multiple power conversion stages down to the chip-voltage level. In order to increase the efficiency of the power supply chain, the number of conversion stages must be substantially reduced. In this context, solid-state transformers (SSTs) are considered as a possible solution, as they could directly interface the MV AC grid to a 400 V DC bus, whereby server racks with a power consumption of several tens of kilowatts could be directly supplied from an individual SST. With a focus on the lowest system complexity, the SST, ideally, should be built as simple two-stage system consisting of an MV AC/DC power factor correction (PFC) rectifier stage followed by an isolated DC/DC converter. Accordingly, this paper focuses on the design and realization of a 25 kW, 3.8 kV single-phase AC to 7 kV DC PFC rectifier unit based on the 10 kV SiC MOSFETs. By simply adding an $LC$ circuit between the switch nodes of the well-known full-bridge-based pulse width modulated AC/DC rectifier, the integrated triangular current-mode concept is implemented, which only internally superimposes a large triangular current ripple on the AC mains current and, therefore, enables zero-voltage switching over the entire AC mains period. Special attention is paid to the realization of the MV inductors and their electrical insulation, the AC-input $LCL$ filter to limit electromagnetic interference emissions, and the challenges arising due to cable resonances when connecting the SST to the MV grid via an MV cable. Despite the large insulation distances required for MV, the realized 25 kW MV PFC rectifier achieves an unprecedented power density of 3.28 kW/L (54 W/ $\mathrm {in}^{3}$ ) and a full-load efficiency of 99.1%, determined using a calorimetric measurement setup, which is discussed in detail in the Appendix.

99.2%Efficiency ZVS Single-phase PFC Rectifier with SiC MOSFET

Analytical Calculation of the Residual ZVS Losses of TCM-Operated Single-Phase PFC Rectifiers

Efficiency Optimization of 40 Kw CAC-ZVS Three-phase PWM Rectifier

High efficiency power factor correction power supply based on SiC device

High Power Three-Level Rectifier Comprising SiC MOSFET & Si Diode Hybrid Power Stage

A High Efficiency Two-Stage ZVS AC/DC Converter with All SiC MOSFET

An SiC MOSFET & Si Diode Hybrid Three-Phase High-Power Three-level Rectifier

Single-Phase Single-Stage Isolated ZCS Current-Fed Full-Bridge Converter for High-Power AC/DC Applications

ZVS range extension of 10A 15kV SiC MOSFET based 20kW Dual Active Half Bridge (DHB) DC-DC converter

SiC Full-Bridge Grid-Tied Inverter with ZVS-switching

High-Efficiency High-Density Critical Mode Rectifier/Inverter for WBG-Device-Based On-Board Charger

A Novel ZVS Dual Bridge DC/DC Converter Using SiC Schottky Diode

Totem-Pole Boost Bridgeless PFC Rectifier With Simple Zero-Current Detection and Full-Range ZVS Operating at the Boundary of DCM/CCM

Hybrid SiC-Si DC–AC Topology: SHEPWM Si-IGBT Master Unit Handling High Power Integrated with Partial-Power SiC-MOSFET Slave Unit Improving Performance

Efficiency improvement of a SiC-MOSFET 500 kHz ZVS inverter

Sic Mosfet Zero-Voltage-Switching Svm Controlled Three-Phase Grid Inverter

Silicon carbide-based digitally controlled zero voltage switching dual-phase interleaved totem-pole PFC rectifier operating at high frequency

Characteristics of SiC MOSFET and its application in a phase-shift full-bridge converter

Efficiency Improvement of Grid Inverters With Hybrid Devices

A ZCS AC/DC CONVERTER WITH HIGH POWER FACTOR BASED ON PWM CONTROL STRATEGY

99.1% Efficient 10 kV SiC-Based Medium-Voltage ZVS Bidirectional Single-Phase PFC AC/DC Stage