Abstract:In the last few years, broadband and switchable frequency selective surfaces (FSSs) absorber/reflector are of great importance in different areas such as stealth system, EM interference, EM compatibility, and so on. In this paper, to obtain a switchable frequency selective surfaces absorber/reflector in different states, a broadband and switchable absorber using an absorb/reflective FSS is presented. The top layer of the proposed switchable absorber is a periodic arrangement of square loops loaded with PIN diodes on a dielectric substrate which has a sufficient mechanical strength to hold up all the units, and under the square loops there are honeycomb of a certain thickness and a thin layer of metal. The structure has been characterized with the full-wave analysis and shows good absorption/reflection switching performance. Intrinsic impedance of proposed structure has also been investigated to explain the switching and the broadband absorption mechanisms of the structure. The working frequency band of the switchable absorbing structure is 2.5 ~ 5.5 GHz, and it switches states by changing the bias voltage. Biasing at different voltages to turn ON and OFF the diodes, the FSS structure can switch freely between absorption and reflection state. In ON state, the switchable FSS has two states working as a wideband absorber and the reflectivity in 2.5 ~ 5.5 GHz is below -10 dB, while in OFF state it has fine reflective property. In addition, inductances are used to connect each element of the structure to achieve the purpose of broadband isolation. Simulation and measurement results demonstrate the performance of the proposed structure.

The SPUDT Technology for the Design and Fabrication of Filters and Switches in Communication System

Analysis and Design of Single-Phase Unidirectional Transducers with High Directivity

3D Heterogenous Integrated Wideband Switchable Bandpass Filter Bank for Millimeter Wave Applications

Non‐Hermitian Loss‐driven Broadband Low‐Loss On‐chip Terahertz Photonic SPDT Switch

A Design of V-band Reconfigurable SPDT Switch/Power Divider Based on Slotted SIW

Compact Substrate Integrated Waveguide (SIW) Filter with Defected Ground Structure

Switchable Frequency Selective Surfaces Absorber/reflector for Wideband Applications

Integrated Acousto-Optic Tunable Filter, Equalizer, and Switch in WDM Communication System

The extensive experimental researches on AOTF in WDM system

Design of a Broadband and Switchable Absorber Using an Absorb/Reflective FSS

A broadband low‐loss SPDT RF switch using a new off‐chip compensation technology

Near 30% Fractional Bandwidth Surface Acoustic Wave Filters with Novel Electrode Configuration

Integrated Broadband Filter with Sharp Transition Edges Based on SiN and SiON Composite Waveguide Coupler

Research on the integrated filter and switch in the application of fiber-optic communication

Research and Fabrication of High-Frequency Broadband and Omnidirectional Transmitting Transducer

Designed Structures of Interdigital Electrodes for Thin Film SAW Devices

High Speed Integrated Acousto-Optic Switch with High Extinction Ratio

Design of Miniaturized Narrow-Band POI-SAW Filter Using Mixed Ladder-DMS Topology

A Low-Loss Wideband SAW Filter with Low Drift Using Multilayered Structure

Tilted IDT Designs for Spurious Modes Suppression in LiNbO3/SiO2/Si SAW Resonators

Structure With Thin Siox/Sinx Bilayer And Al Electrodes For High-Frequency, Large-Coupling, And Low-Cost Surface Acoustic Wave Devices