Abstract:This paper proposes a peak time of voltage travelling wave‐based protection scheme for DN with distributed generators using FRs as line boundary. Numerical simulation and experimental results verify that the proposed method can quickly and sensitively distinguish internal and external faults, and has high resistance to transition resistance. There exist problems of hard coordination and threshold setting as well as low sensitivity in overcurrent relay due to the bidirectional and small fault current when distributed generators are integrated into the distribution network. This paper introduces ferrite rings (FRs) to act as boundaries of distribution feeders, and a peak time of voltage traveling wave‐based protection is proposed. The characteristics of FRs are analyzed and their feasibility as line boundary is validated. The fault characteristics of internal and external faults are analyzed when FRs are installed at both ends of the protected feeder. The results show that the peak time of the voltage travelling wave of the internal fault is far smaller than that of the external faults. According to the difference, the fault detection method and the protection scheme are proposed. Simulations in PSCAD and experiment validate that the proposed protection principle can reliably distinguish between internal and external faults. Besides, the proposed protection scheme has higher sensitivity compared to ROCOV‐based protection.

Non-communication Protection of Distribution Feeders with Tapped-off-loads

Accelerated Protection of Distribution Systems with Tapped off Loads

NON-COMMUNICATION PROTECTION FOR DISTRIBUTION SYSTEMS WITH THE TAPPED-LOAD

A new non-communication relay for protection of feeders

An Adaptive Noncommunication Protection for Distribution Systems

NON-COMMUNICATION PROTECTION FOR POWER LINES IN DISTRIBUTION SYSTEM

Non-communication Protection for Radial Connected Distribution Systems

Non-communication Protection for Single-Phase-to-Ground Fault Feeder in Neutral Non-Effectively Grounded Distribution System

Adaptive non-communication protection for transmission lines. Part I: Fault analysis and protection principle

A new distribution automation technique without the need for communication link

Feeder Automation System Based on Non-Communication Protection and Control Unit

Scheme of Accelerated Overcurrent Protection for Distribution Systems with IDMT Coordination

Integrated protection of distribution network using multi-channel technique

Under Voltage Accelerated Protection of Single Source Distribution Systems

A field scheme of feeder automation system based on non-communication protection

Research on non-communication protection of distribution lines based on fault components

Evaluation of an accelerated overcurrent protection for single circuit breaker distribution feeder

A high speed and sensitive protection for distribution network with DGs using ferrite rings as line boundary

Distribution Line Automation System Based on Non-Communication Protection in the Case of Symmetrical Fault

A novel non-communication protection based on adaptive tripping and reclosure technique for transmission lines

Integrated Protection Of Distribution Lines Using Transient Comparison Technique