Abstract:Rising penetration of converter-based sources with different control operations is introducing severe non-homogeneity in the power systems, especially during faults. Such non-homogeneity leads the decision derived by available distance and directional relays to be unreliable. Performances of the available communication-assisted tripping schemes being dependent on these two relay decisions at both ends become a concern for the protection of converter-dominated power networks. This work demonstrates the impact of converter-based sources on both distance and directional relays and the possible maloperation of the accelerated protection schemes. A new transfer trip scheme has been proposed mitigating the issue. Considering the homogeneity present in the negative and zero sequence networks in high voltage transmission system even with converter-based sources, two indices are derived using local voltage and current data to identify the fault direction at each end of a protected line. The decisions are transferred to the alternative ends through low-bandwidth communication channels to ensure the protection decision derived for the line to be dependable as well as secured. The scheme is tested for a 9-bus and a 39-bus system, even with 100% converter-based sources using PSCAD/ EMTDC simulation platform and found to be reliable for different faults and system conditions. Comparative assessment with a few advanced techniques demonstrates the superiority of the proposed method.

Under Voltage Accelerated Protection of Single Source Distribution Systems

A new distribution automation technique without the need for communication link

Accelerated Protection of Distribution Systems with Tapped off Loads

An Adaptive Noncommunication Protection for Distribution Systems

Scheme of Accelerated Overcurrent Protection for Distribution Systems with IDMT Coordination

A Reliable Accelerated Protection Scheme for Converter-Dominated Power Networks

Regional Area Protection Scheme for Modern Distribution System

Overcurrent Relay Based Integrated Protection Scheme for Distribution Systems

Integrated protection of distribution network using multi-channel technique

Distribution Line Automation System Based on Non-Communication Protection in the Case of Symmetrical Fault

Non-communication Protection for Radial Connected Distribution Systems

Non-communication Protection of Distribution Feeders with Tapped-off-loads

NON-COMMUNICATION PROTECTION FOR DISTRIBUTION SYSTEMS WITH THE TAPPED-LOAD

NON-COMMUNICATION PROTECTION FOR POWER LINES IN DISTRIBUTION SYSTEM

Evaluation of an accelerated overcurrent protection for single circuit breaker distribution feeder

A Traveling-Wave-based Line Protection Strategy Against Single-Line-to-ground Faults in Active Distribution Networks

The Relay Protection Scheme for Distribution Network with Distributed Generations

A New Protection Scheme for High Impedance Fault Using Adaptive Trip and Reclosure Technique

A Scheme of the Fast Tripping Current Protection for Distribution Lines Based on the Voltage Sag Mitigation

A new non-communication relay for protection of feeders

Novel directional comparison protection for distribution lines