Abstract:Summary form only given. Because of higher hold-off voltage and higher current than power semiconductor such as GTO, MOSFET, PCSS, SOS etc., spark gap switches are generally used in the last output stage of high power modulator. But its recovery time is millisecond level, so it is prevented on the high rep-rate conditions. The gaseous recovery in a spark gap was investigated by using Two-pulses method with which the tested spark gap was broken down twice by two identical voltage pulses with a preset time interval in between. While the first breakdown is overvolted breakdown, the second breakdown happens usually at a voltage much lower than the first one. By comparing the two breakdown voltages the gaseous recovery as a function of the time interval between the two voltage pulses was obtained. There are two plateaus on the curve of the breakdown voltage recovery. The first plateau appears at the voltage of about the DC static breakdown and the second one appears when the gas is almost fully recovered. It was found that the shorter gaps at all nitrogen pressure tend to recover faster and the gaps with higher pressure also tend to recover faster. If more energy is deposited in the spark channel produced by the first breakdown, the gas insulation recovers slower. Both the first breakdown voltage and the second one obey Gaussian distribution. If the second breakdown happens at the point before the end of the first plateau on the curve of the breakdown voltage recovery, its mean square deviation of the breakdown voltage distribution will be smaller than that of the first breakdown. By taking photographs of the discharge in the spark gap, it was important to find that the spark channel produced by the second breakdown usually does not follow that by the first breakdown. The second spark channel is located with a distance of 0~3 mm from the first one. The longer is the time interval between the two voltage pulses, the larger is the distance.

Analysis of the characteristics of gas insulated, multiple-stage, high voltage switches

Study of operation mode and breakdown characteristics for multi-stage gas switch

Computation of Transient Electromagnetic Field Emission from GIS Enclosure During Disconnector Switching Operations

Research on DC Breakdown Characteristics for the Insulation of 10 Kv AC XLPE Cables

Investigating the characteristics of internal discharge shock waves in gas‐insulated switchgear under varied gap configurations

Investigation on Breakdown Characteristics of a Pulsed Gas Switch and Influence of Pre-Ionization

DC switching overvoltage of ± 1100 kV UHVDC converter station

Experimental Study on Fast Isolating Switch with Vacuum Multi-breaks

Research of simulation and experiment on arc characteristics of gas mechanical switch

A Multi-Break Mechanical Switch Applicable for Medium Voltage Natural Commutation DC Circuit Breakers

Switching Impulse Breakdown Characteristics of Large Sphere-Plane Air Gaps Compared with Rod-Plane Air Gap

“Multi-Particle-in-Series” Phenomenon and Discharge Properties Induced by Multiple Free Particles in GIS

Statistical analysis of switching overvoltages in UHV transmission lines with a controlled switching

Breakdown characteristics of gas switch under nanosecond pulse voltage

Experimental Research on Very-Fast Transient Overvoltage in 1100-Kv Gas-Insulated Switchgear

Preliminary Research on Breakdown Mechanism of Gas Switch

Simulation and Characterization of Micro-Discharge Phenomena Induced by Glitch Micro-Defects on an Insulated Pull Rod Surface

Defects and failure types of solid insulation in gas‐insulated switchgear: In situ study and case analysis

Numerical Modeling of Different Streamer Breakdown Modes of Gas Switch under the External Circuit

Overvolted breakdown and recovery characteristic of spark gap switch

Impact of overvoltage on the mode transition of the spark gap switch: from edge breakdown to stochastic breakdown