Abstract:The rise of 5th generation (5G) communication, satellite communication and radars has been boosting the demand for millimeter wave (mm-wave) phased array frontends. Bandwidth and chip area are two crucial performance merits of mm-wave phased array frontends. Wide bandwidth is necessary to support high-speed communications at various 5G frequency bands, or improve the range resolution in radar applications. On one hand, the large area consumption increases the chip cost. One the other hand, in a large-scale phased array system, the maximal allowed chip area for each signal channel is set by the antenna element space, which is usually the half wavelength to avoid grating lobes. It would be very difficult to feed each antenna element if the chip area is too large. A sparse antenna array can relieve the channel area restriction at the cost of possible grating lobes or a narrower beam scanning range. Fig. 1 top-left shows the block diagram and layout floorplan of a typical mm-wave phased array frontend. In mm-wave frontends, on-chip transformer-based matching networks are extensively used due to their compact layout, easy DC bias connection and potential to achieve wideband matching. As shown in the Fig. 1 top-left, the chip area of a mm-wave phased array frontend is dominated by transformers. What makes the situation worse is that the area of on-chip transformers doesn’t scale as much as transistors along with the process advancement. Therefore, transformers are increasingly expensive in the advanced process nodes.

An Integrated Stacked Transformer With Large Inductance At 900mhz

Stacked Spiral Inductor Design and Modeling for Fully-Integrated DC-DC Converters

Three-solenoid Windings Transformer Baluns on CMOS-grade Silicon Substrate

Comparative investigation on various on-chip center-tapped interleaved transformers: Research Articles

A Study of On-Chip Stacked Multiloop Spiral Inductors

Design and Wafer-Level Fabrication of Stacked-Type Transformers for High-Density Power Converters

Design of Millimeter-Wave Transformer Balun with Isolation Circuit in Silicon Based Technology

Analysis, Design, and Implementation of a Spatially Nested Magnetic Integration Method for Inductive Power Transfer Systems

Comparative Investigation On Various On-Chip Center-Tapped Interleaved Transformers

Vertical Topologies of Miniature Multispiral Stacked Inductors

A Compact Multilayer-Stacked Guanella Transformer Based 50–680-Mhz GaAs Power Amplifier

High-Density Planar Integrated Magnetics with Two-Sided Merged Inductor Windings and Integrated Cores for Resonant DC/DC Converter

An Optimization Design for Transformer and Output Filter of a Micro-inverter with Passive Integration Technique

An Integrated Structure for Transformer and Output Filter of a Micro-inverter with Flexible Multilayer Foil Technique

Integrated On-Chip Transformers: Recent Progress in the Design, Layout, Modeling and Fabrication

A 3D Assembled Silicon-Embedded Transformer for 10-Mhz, Ultra-High-Isolation, Compact Chip-to-Chip Power Transfer

INTEGRATED STACKED-SPIRAL RF INDUCTOR WITH NANOPOWDER MAGNETIC CORE

An Ultra-Compact 16-to-45 GHz Power Amplifier Within A Single Inductor Footprint Using Folded Transformer Technique

A High Power Density 48V-12V DCX with 3-D PCB Winding Transformer

High Quality Factor Integrated Gigahertz Magnetic Transformers with Fegab/Al2o3 Multilayer Films for Radio Frequency Integrated Circuits Applications

Modeling and Design of a Medium Frequency Transformer with High Isolation and High Power-Density