Abstract:The development of radio-frequency integrated circuits (RF-IC) necessitates higher requirements for the size of microtransformers. This paper describes millimeter-scale 3D transformers in millimeter-scale, solenoidal, and toroidal transformers manufactured using Micro-electromechanical Systems (MEMS). Two through-silicon via (TSV) copper coils with a high aspect ratio are precisely interleaved on a reserved air core (magnet core cavity) with a vertical height of over 1 mm because of the thickness of the substrate, which increases the performance while reducing the footprint. The effects of the wire width, coil turns, magnetic core, and substrate on the performance of the two transformers are discussed through numerical simulations. When an air core is present, solenoidal transformers are better than toroidal transformers in terms of performance and footprint; however, the gap decreases when the size is reduced. Additionally, the magnetic core significantly improves the performance of the toroidal transformer compared to that of the solenoid. Thus, the toroidal transformer has a higher potential for further size reduction. The two types of transformers were then manufactured completely using MEMS and electroplating. This paper discusses the influence of various parameters on millimeter-scale 3D transformers and realizes processing in silicon, which provides the foundation for integrating transformers in a chip.

A 3D Assembled Silicon-Embedded Transformer for 10-Mhz, Ultra-High-Isolation, Compact Chip-to-Chip Power Transfer

A High Power Density 48V-12V DCX with 3-D PCB Winding Transformer

Novel Through-Silicon-Via Inductor-Based On-Chip DC-DC Converter Designs in 3D ICs

A novel PCB winding transformer with controllable leakage integration for a 6.6kW 500kHz high efficiency high density bi-directional on-board charger

A Fully Integrated, Low-Cost, High Channel Utilization Digital Isolator in Standard CMOS with 50mbps and 100kv/μs CMTI

High Power Density 48–12 V DCX with 3-D PCB Winding Transformer

A WBG based three phase 12.5 kW 500 kHz CLLC resonant converter with integrated PCB winding transformer

Design of Millimeter-Wave Transformer Balun with Isolation Circuit in Silicon Based Technology

Three-solenoid Windings Transformer Baluns on CMOS-grade Silicon Substrate

&Amp;#x0022;green&#x0022; On-chip Inductors in Three-Dimensional Integrated Circuits

Design and Wafer-Level Fabrication of Stacked-Type Transformers for High-Density Power Converters

Wafer-Level Fabricated Tight-Coupling Dual-Solenoid Transformer Chips With Watt -Scale Power Transfer

Modeling and Design of a Medium Frequency Transformer with High Isolation and High Power-Density

High Efficiency High Power Density Cellular 1mhz 380V-12V DCX for Future Data Centers

A High-Voltage-Isolated MEMS Quad–Solenoid Transformer with Specific Insulation Barriers for Miniaturized Galvanically Isolated Power Applications

Design and Manufacture of Millimeter-Scale 3D Transformers for RF-IC

A High Power High Isolation Medium Frequency Transformer With A Planar Matrix Structure

Design and Fabrication of Integrated Superconducting Isolator-Circulator-isolator Chip

Non-Magnetic Resonant-Type High-Frequency High-Voltage Power Conversion with Silicon Carbide Power Semiconductor Devices

Integrated Planar Transformer for High-Voltage-Ratio LLC DCX with High Current and Ultra-Low Voltage Output

MEMS-Casting Fabricated Chip-Style 3D Metal Solenoidal Transformers towards Integrated Power Supply