Abstract:Ceramic cutting tool materials possess specific advantages, including high hardness, excellent wear resistance, and high chemical stability, making them unparalleled in the machining of difficult-to-process materials compared to traditional cutting tools. The mechanical performance of these materials is primarily determined by their microstructure. Therefore, it is necessary to simulate and optimize the microstructure of ceramic cutting tool materials to provide theoretical guidance for further enhancing their fracture toughness. In this paper, a simulation model based on sintering densification theory was proposed, coupling crystal plasticity with a three-dimensional cellular automaton, to investigate the impact of nanoparticle content, sintering temperature , sintering pressure, and holding time on grain growth in composite ceramic materials using spark plasma sintering (SPS). Furthermore, an evolution model for grain growth of TiB 2 -TiC-SiC nanocomposite ceramic materials in cutting tools is established, and the optimal sintering process parameters are obtained. Finally, SPS experiments were conducted. Under the conditions of a sintering temperature of 1600 °C, holding time of 7 min, and sintering pressure of 40 MPa, optimal mechanical performance composite ceramic cutting tool materials were prepared. The experimental results, including a hardness of 25.6 GPa, fracture toughness of 7.1 MPa·m 1/2 , and flexural strength of 628.2 MPa, were consistent with the simulation outcomes. This indicates that the designed simulation model for nanocomposite ceramic grain growth reliably reflects the physical process of grain growth in the material and provides valuable guidance for further understanding the mechanisms underlying grain growth.

Prediction of macroscopic effective elastic modulus of micro-nano-composite ceramic tool materials based on microstructure model

Macro-micro Analysis of Mechanical Properties of Al0.6CoCrFeNi High-Entropy Alloy Particle-Reinforced Al-based Composites

Micromechanical Simulation on Strength and Ductility of Two Kinds of Al-based Nanostructural Materials

FEM Simulation of Dielectric Properties of Composite Ceramics

MODELLING THE YIELD STRENGTH AND DUCTILITY IN COMPOSITE NANOTWINNED COPPER

Prediction of Mechanical Properties in Bimodal Nanotwinned Metals with a Composite Structure

Micromechanical modeling for mechanical properties of gradient-nanotwinned metals with a composite microstructure

Simulating Size and Volume Fraction-Dependent Strength and Ductility of Nanotwinned Composite Copper

Optimization of sintering parameters for fabrication of Al2O3/TiN/TiC micro-nano-composite ceramic tool material based on microstructure evolution simulation

Micromechanics-based modeling of elastic modulus and coefficient of thermal expansion for CNT-metal nanocomposites: effects of waviness, clustering and aluminum carbide layer

A modified Halpin–Tsai model for predicting the elastic modulus of composite materials

Investigation on A Direct Modeling Strategy for the Effective Elastic Moduli Prediction of Composite Material

MECHANICAL PROPERTIES AND OPTIMAL ANALYSIS ON VARIOUS LEVEL MICRO-COMPOUNDED CERAMIC COMPOSITE

Three-dimensional modeling of grain structure growth within ceramic tool material

Microstructure and performance optimization of Al2O3/TiC/TiB2/h-BN@Al2O3 self-lubricating ceramic tool materials

An Effective Model for the Elastic Behavior of Two-Phase Materials Based on Structural Recognition

A Micromechanical Model for Interpenetrating Multiphase Composites

Understanding the Effect of Microstructure on the Failure Behavior of Additively Manufactured Al 2 O 3 Ceramics: 3D Micromechanical Modeling

Microstructure based analysis and predictive modeling of cast Al7Si1.5Cu0.4Mg alloy mechanical properties

A novel strategy in micomechanics modeling of silica fibrous ceramics considering morphology-related sintering effects

Numerical modeling and failure evolution of microstructure-based in-situ TiB2 and TiC+TiB2 reinforced Cu matrix composites