Microstructure and Performance Evaluations on Q&P Hot Stamping Parts of Several UHSS Sheet Metals
XianHong Han,YaoYao Zhong,ShuLin Tan,YaNan Ding,Jun Chen
DOI: https://doi.org/10.1007/s11431-016-9111-y
2017-01-01
Science China Technological Sciences
Abstract:Hot stamping (press hardening) is widely used to fabricate safety components such as door beams and B pillars with increased strength via quenching. However, parts that are hot-stamped from ultra-high-strength steel (UHSS) have very limited elongation, i.e., low ductility. In the present study, a novel variant of hot stamping technology called quenching-and-partitioning (Q&P) hot stamping was developed. This approach was tested on several UHSS sheet metals, and it was confirmed that this method can be used to overcome the drawbacks associated with conventional hot stamping. The applicability of Q&P hot stamping to each of these steels was also assessed. The part properties and performances of three widely used ultra-high-strength sheet metals, B1500HS, 27SiMn, and TRIP780, were evaluated through tensile testing and microstructural observations. The results demonstrated that the ductility of Q&P hot-stamped sheet metals was notably higher than that of the conventionally hot-stamped parts because Q&P hot stamping gives rise to a dual-phase structure of both martensite and austenite. Further, material tests demonstrated that the Q&P treatment had positive effects on all three selected materials, of which TRIP780 had the best ductility and the highest value of the product of strength and plasticity. Scanning electron microscopy images indicated that the silicon in the steels could limit the formation of cementite and would, therefore, improve the mechanical properties of Q&P hot-stamped products.