Abstract:The central deformation extent of the thick plate can be improved and the approaching uniform deformation will be realized by the snake/gradient temperature rolling (SGTR). At present, the existing rolling force analytical models cannot be directly used for SGTR because of the great difference with the synchronous rolling. The rolling force model should be established so as to meet the production demand of the SGTR with different roll diameters. The thick plate is divided into three layers according to the numerical results of the short-term ultra-fast cooling for the thick plate. The deformation region is simplified into different zones and layers according to the temperature gradient and neutral point position. The traditional von Mises yield criterion was optimized by the introduced coefficients c1 and c2 according to the slip line field theory to correct the deviation caused by the uniform and shear stress assumption. The specific pressure equation is established by the slab method. The deformation region with different composition cases is analyzed, and the rolling force and torque analytical models are established according to the boundary conditions on this basis. The short-term ultra-fast cooling and rolling process were simulated by ANSYS software. The deformation resistance gradient produced by short-term ultra-fast cooling and roll diameter ratio are the main factors to affect the rolling force, while the roll offset has little effect on the rolling force because of its small proportion in the deformation region. The position of neutral points not only affects the rolling torque, but also changes its direction in certain conditions. The model precision was analyzed, and the rolling force calculated by the established analytic model is in good agreement with the numerical method, which serves as a theoretical basis for the rolling mill design and process parameter setting.

3-D Numerical Simulation of Aluminum Strip Steering Process under Asymmetric Variations in Hot Rolling

3-D SIMULATION AND STUDY ON ALUMINIUM STRIP'S RUNNING DEVIATION IN HOT ROLLING PROCESS

The Modeling of Trajectory Deviation and Deviation Direction in Aluminum Hot Tandem Mill

Study on mechanical parameters and strip steering of aluminium alloy JP1235 under the influence of mill tilt

Numerical Simulation of the Asymmetric Unstable Situation in Hot Continuous Rolling of Aluminium Alloy

Theory and Simulation of Roll Gap Manipulation for Controlling the Strip Steering During Aluminum Hot Rolling

Model and Simulation of Tension Manipulation for Controlling the Strip Steering During Wide Aluminum Hot Rolling

The Three-Dimensioned Thermo-Mechanical Coupled Simulation Analysis of Hot Rolling Process of the Aluminum Alloy Strip

Transfer Model of Transverse Asymmetry Characteristic in Standers During the Steady Hot Rolling Stage

Numerical simulation of cold longitudinal asymmetric rolling process

The tail deviation of the aluminum strip hot rolling control model and its simulation

Balance regulation model and numerical simulation on lateral non-symmetrical phenomenon in hot rolled Al alloys

Numerical Simulation and Experimental of Forming Defects in Roll-Bending Process for Z-Shaped Profiles With Large Cross-Section

Asymmetric shape control theory and practice in hot strip mills and cold strip mills

Aluminum Hot Finishing Rolling Three-Dimensional Finite Element Simulation of Temperature Field in the Rolling Area

ASR Bending Force Mathematical Model for the Same Width Strip Rolling Campaigns in Hot Rolling

Numerical simulation of aluminum alloy hot rolling using DEFORM-3D

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters

Numerical Simulation and Parameter Design of Strip Cold Rolling Process of 301L Stainless Steel in 20-Roll Mill

Asymmetric Shape Control Ability and Mutual Influence of the S6-High Cold Rolling Mill

Numerical simulation of influence of process parameters on aluminum plate's temperature drop during hot rolling