Abstract:The central deformation extent of the thick plate can be improved and the approaching uniform deformation will be realized by the snake/gradient temperature rolling (SGTR). At present, the existing rolling force analytical models cannot be directly used for SGTR because of the great difference with the synchronous rolling. The rolling force model should be established so as to meet the production demand of the SGTR with different roll diameters. The thick plate is divided into three layers according to the numerical results of the short-term ultra-fast cooling for the thick plate. The deformation region is simplified into different zones and layers according to the temperature gradient and neutral point position. The traditional von Mises yield criterion was optimized by the introduced coefficients c1 and c2 according to the slip line field theory to correct the deviation caused by the uniform and shear stress assumption. The specific pressure equation is established by the slab method. The deformation region with different composition cases is analyzed, and the rolling force and torque analytical models are established according to the boundary conditions on this basis. The short-term ultra-fast cooling and rolling process were simulated by ANSYS software. The deformation resistance gradient produced by short-term ultra-fast cooling and roll diameter ratio are the main factors to affect the rolling force, while the roll offset has little effect on the rolling force because of its small proportion in the deformation region. The position of neutral points not only affects the rolling torque, but also changes its direction in certain conditions. The model precision was analyzed, and the rolling force calculated by the established analytic model is in good agreement with the numerical method, which serves as a theoretical basis for the rolling mill design and process parameter setting.

Balance regulation model and numerical simulation on lateral non-symmetrical phenomenon in hot rolled Al alloys

The central strain analytical modeling and analysis for the plate rolling process

Calculation and analysis of rolling force during aluminum alloy thick plate snake/gradient temperature rolling with different roll diameters

Theoretical Study of Asymmetric Bending Force on Metal Deformation in Cold Rolling

Bending analysis and control of rolled plate during snake hot rolling

FE simulation of multi-pass reversible hot rolling of GH4169 alloy plate

A Study on Compressive Anisotropy and Nonassociated Flow Plasticity of the AZ31 Magnesium Alloy in Hot Rolling

Analytic Numerical Modeling for Thermal Mechanical Processing of Plate under Rolling

Asymmetric Shape Control Ability and Mutual Influence of the S6-High Cold Rolling Mill

Research on the analytical model of rolling force for TiAl alloy pack rolling

Prediction and analysis of rolling process temperature field for silicon steel in tandem cold rolling

Modeling of 3D Plastic Anisotropy and Asymmetry of Extruded Magnesium Alloy and Its Applications in Three-Point Bending

The Finite Element Analysis for Dimensional Accuracy in Roll Bending of Aluminum-Polymer Laminated Sheet

ASR Bending Force Mathematical Model for the Same Width Strip Rolling Campaigns in Hot Rolling

Variation laws and influencing factors of lateral spread of the cold-rolled thin steel in rolling process

Numerical Simulation and Parameters Analysis for Roll Forming of Martensitic Steel MS980

Mathematical modeling and simulated analysis of metal flow behavior during the FGC of ESP rolling process

Numerical Simulation of Cast-rolling Process for Copper-Aluminum Composite Plate

Analysis of Temperature Asymmetry of Aluminum Alloy Thick Plate During Snake Hot Rolling

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

A modeling of residual stress in stretched aluminum alloy plate