Abstract:A new thermomechanical process consisting of heavy cold rolling (HCR) and short-time heat treatment (STH) is developed to fabricate fine-grained martensite microstructure in a low-cost plain low-carbon steel. To achieve the optimal mechanical properties after STH, three different ferrite-pearlite (F-P) dual-phase microstructures are prepared via hot rolling (HR), HR and austenitizing, and HR and HCR. The microstructure evolution and the comprehensive mechanical properties of the alloy during STH are then investigated. We find that the volume fractions of transformed martensite after STH increase with decreasing grain sizes of the pre-STH F-P dual phases. The rapid heating and short-time holding of STH promote grain nucleation and inhibit grain growth, resulting in microstructure refinement. The formation of martensites with different morphologies and different carbon concentrations in the HR and HCR + STH alloy is identified, owing to the inhomogeneous carbon distribution by STH. Tensile experiments demonstrate that STH greatly improves the comprehension mechanical properties of the alloy. Excellent mechanical properties, with a yield strength of 1224 MPa, a tensile strength of 1583 MPa, a uniform elongation of 4.0% and a total elongation of 7.3% are achieved in the HR and HCR + STH alloy. These excellent mechanical properties are principally attributed to the microstructure refinement and martensite formation induced by STH, with a yield strength improvement of 134% and a tensile strength improvement of 150% relative to the HR alloy.

Microstructure and mechanical properties of a hot-rolled 30CrMo steel produced by compact strip production

Mechanical Properties of Heat Treated 30crmo Steel Produced by Compact Strip Production

Microstructure and Mechanical Properties of Hot-rolled 65mn Steel Produced by CSP

The CSP Process Development of the Press Hardening Steel

Microstructures and Mechanical Properties of Low Carbon Steel Hot Rolled in Ferrite Region Based on CSP Line

Analysis of Microstructure and Mechanical Properties of 30CrMo Steel During Annealing After Cold Rolling

Mechanical Properties of Heat Treated 65mn Steel Produced by Compact Strip Production

Microstructural Evolution and Mechanical Properties of 6cr13 Martensitic Stainless Steel Subjected to Cold Rolling and Heat Treatments

Microstructural evolution and grain refinement of a high strength low alloy steel produced by compact strip production

Practice on a High Carbon High Strength Steel Produced by Compact Strip Production

Effect of Cooling Process on Microstructure and Mechanical Properties of Hot Rolled 65Mn Steel

Microstructure and Properties of Cold Rolled Cu70Cr30 Composite

Microstructural Characterization of Non-Oriented Low Silicon Steel Produced by Compact Strip Production

Achieving Fine-Grained Microstructure and Superior Mechanical Property in a Plain Low-Carbon Steel Using Heavy Cold Rolling Combined with Short-Time Heat Treatment

CCT Diagram and Hardenability of 65mn Steel Produced by Compact Strip Production

Microstructure evolution and compressive properties of a low carbon-low alloy steel processed by warm rolling and subsequent annealing

Importance of cold rolling and tempering on the microstructure evolution, precipitation behavior and mechanical responses of 9Cr3Co3W1Cu ferritic/martensitic steel

Precipitates in High Strength Hot-rolled Strip for Automobile Pilot Produced by CSP Technology

Effect of Cyclic Warm-Rolling Technique on Mechanical Properties of MoCu30 Thin Plates with Heterogeneous Structure

Microstructures, Mechanical Properties and Deformation of Near-Rapidly Solidified Low-Density Fe-20Mn-9Al-1.2C-xCr Steels

Impurity-free and high-efficiency modification for 30CrMo steel