Abstract:This article presents an eight-element 17.7–19.2-GHz receiver front end with 1–2 concurrent beams in a 65-nm CMOS technology. Each output beam utilizes a temperature-compensation variable-gain amplifier (TC-VGA) to minimize the temperature-induced gain variation. The concept of the proposed TC-VGA and the realization of corresponding adaptive analog control are introduced in detail. The front-end architecture and circuit-level design to enable a flat wideband gain response, precise phase and amplitude control, low power consumption, and adaptive analog temperature compensation are presented. Wafer probing is conducted to measure the performance of the receiver front end. The measured gain-temperature coefficient is ±0.005 dB/°C from −15°C to 85 °C at 17.7–19.2 GHz, while the counterpart without temperature compensation is −0.1 dB/°C. The chip demonstrates a 28-dB power gain, a 26% 3-dB fractional bandwidth, a 3.2–4.1-dB noise figure (NF), and a −27.4-dBm input 1-dB gain compression point (IP $_{\mathrm {1\,dB}}$ ) for each element. In addition, each channel provides 7-bit phase-shifting resolution and 6-bit attenuation for a 15.75-dB gain range with a <1.5° root-mean-square (rms) phase error, and a < 0.22-dB rms amplitude error. The chip occupies $4.65\times2.77$ mm2 area with pads, equivalent to 1.61 mm2 per element (for two beams), and consumes 37.2 mW per element per beam. To the best of our knowledge, the receiver front end demonstrates the minimum gain variation with temperature among silicon RF-beamforming front ends.

Analysis and Design of a 1.8–2.7 GHz Tunable 8-Band TDD LTE Receiver Front-End

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A 17.7–19.2-Ghz Receiver Front End with an Adaptive Analog Temperature- Compensation Scheme

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

An 800-Ps Origami True-Time-Delay-Based CMOS Receiver Front End for 6.5–9-Ghz Phased Arrays

A 0.7-8 GHz High IF Frequency-Extended Transmitter Front-End with −47.1-Db EVM at 16 QAM in 65-Nm CMOS

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A Ka-band 8-Element 4-Beam Transmitter Front End with Hybrid VGA and Symmetrical Transformer-based Doherty PA

A 0.1∼4GHz receiver and 0.1∼6GHz transmitter with reconfigurable 10∼100MHz signal bandwidth in 65nm CMOS

A 0.1 Similar To 4ghz Receiver And 0.1 Similar To 6ghz Transmitter With Reconfigurable 10 Similar To 100mhz Signal Bandwidth In 65nm Cmos

Analysis and Design of a High-Linearity Receiver RF Front-End with an Improved 25%-Duty-cycle LO Generator for WCDMA/GSM Applications

A Power-Area-Efficient, 3-Band, 2-Rx Mimo, Td-Lte Receiver With Direct-Coupled Adc

A 28-/60-GHz Dual-Band Receiver Front-End With Sideband-Selection Technique in 65-nm CMOS

Top-Down Design of 0.8~18ghz Wideband Reconfigurable Receiver Front End with Simulink

Analysis and Design of a 0.9 V 1 GHz-BW 14.6 Dbm-Oip3 Broadband Receiver with Current-Mode Analog Baseband in 12 Nm FinFET CMOS

A 0.1–4 GHz SDR receiver with reconfigurable 10–100 MHz signal bandwidth in 65 nm CMOS

A high-linearity receiver RF front-end with a high-performance 25%-duty-cycle LO generator for WCDMA/GSM applications

A 0.12mm2 K/Ka Band RX Front-end in 40-Nm CMOS with Inductor-Less LO Generators

A -10.1Dbm IIP3, 0.3-40Ghz Receiver Using Hybrid-Path Band-Selection with Reduced LO Coverage Bandwidth Supporting 480mb/s 4096-QAM and 7.2gb/s 64-QAM Modulation

1.9&Amp;amp;#x223c;2.6ghz Tuning Range Variable Gain Low-Noise Amplifier with Digital Assisted Automatic Tuning Loop