Abstract:The integral technology of co-curing has been attracted increasing attention due to its resulting in fewer parts and reduction the assembly times and cost of aircraft structures. In this study, an experimental co-curing technique was applied to fabricate T-stiffened panels in the autoclave, with an emphasis to investigate experimentally on the influence of tool assembly schemes on the manufacture and performance evaluation of co-cured panels. The pressure transferring characteristic of the tools was measured. The thickness analysis and the microscopy observation were examined to discuss the influence of various tool assembly schemes on the compaction of T-stiffened panels. Moreover, a special pull-off test was performed to evaluate the effect of the manufacturing quality on the mechanical performance. The experimental results indicated that during co-curing period, an interesting observation was found that the manufacturing quality of T-stiffened panels was significantly influenced by a position limit for the tools. In case of absence of a position limit for the tools, a micro-cut showed that the fiber waviness obviously appeared in skins and stiffener corners of T-stiffened panels, which was extremely attributed to the pressure distribution in stiffener corners. Applying a position limit for the tools can effectively eliminate the fiber waviness in stiffener corners and a well consolidated T-stiffened panel with uniform thickness was obtained, almost free of fiber waviness and resin-rich defect. Under tension condition, the fiber waviness in stiffener corners remarkably caused a decrease of the initial damage load, but showed no significant influence on the peak load.

Experimental Research on Fiber Compaction of L-shaped Stiffeners in Stiffened Skins by Autoclave Process

Experimental Investigation of the Compaction and Tensile Strength of Co-cured Skin-to-Stiffener Structures

Modeling and experimental validation of compaction pressure distribution for automated fiber placement

Influences of Wrinkles Induced by Tows’ Offset in Automated Fiber Placement on the Bending Properties of Composites

Investigation on Flexural Performance of RC Beams Flexurally Strengthened by Side-bonded CFRP Laminates

Computational modelling of postbuckling behavior of composite T-stiffened panels with different bonding methods

Modeling on the Effect of Automated Fiber Placement Induced Gaps in Curved Composite Laminates

Numerical investigation of the effect of thermal gradients on curing performance of autoclaved laminates

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

Experimental and Numerical Study on Failure Behaviors of Composite Grid Stiffeners under Tensile and Flexural Loading

Interface fracture progression of composite T-stiffened skins fabricated by co-bonding and co-curing under tensile loading: an experimental investigation

Design and optimization of composite sub-stiffened panels

Influence of Process Parameters on the Interlaminar Shear Strength of CF/PEEK Composites In-Situ Consolidated by Laser-Assisted Automated Fiber Placement

Simulation analysis of parametric effects on consolidation ofangle bended composites

Numerical Study on Effects of Interaction between Rubber Mould and Lay-up on Consolidation of L-shaped Laminates in Autoclave Process

Experimental study on the mechanical behavior of laminates made by fiber steering: Influence of fiber angle and tow width

Automated Fiber Placement Path Planning and Analysis of Pressure Vessels

Role of Tool-Part Interaction in Consolidation of L-Shaped Laminates during Autoclave Process

Influence of Fillers on the Post-buckling Behavior of the Hat-Stiffened Composite Panels

Investigation on the influence of temperature, pressure and curing time on the mechanical properties of metal skins and CFRP core sandwich panels manufactured by means of curing-by-forming process

Influence of compaction and curing in the Automated Fiber Placement Process on the mechanical performance of composite laminates