Abstract:Based on the two-dimensional resin flow and fiber compaction model developed by our group, we studied the cured laminate thickness uniformity of the L-shaped CF/BMI resin laminates and the effects of lay-up type and structural elements on it. Both the simulated and experimental data showed that the quasi-isotropic laminate thickness was more uniform than that of the [90°]n laminates and the cured thickness of laminates molded by rigid convex tool was more uniform than that molded by the rigid concave tool. Lay-up type has a great influence on the cured laminate thickness uniformity. For the quasi-isotropic laminates, the structural elements, such as curvature radius, flat part length, and the number of plies, did not have much influence on the cured laminate thickness uniformity in the studied scope. For the [90°]n laminates, the corner radius has a larger effect on the corner consolidation in comparison with the flat part length and the number of plies. According to the simulated results, resin pressure and consolidation time were largely affected by the lay-up type, due to the different permeability and compressibility. The rich resin defect was observed in the metallographic photos of the corner region of the [90°]n laminates fabricated with the rigid concave tool, which demonstrated that the resin flow in the laminates played an important rule and validated the numerical prediction. Good agreement between the simulated results and experimental data demonstrated the reliability and universality of the numerical simulation method. These results are greatly helpful for the control of defects in angle-bended laminates and the optimization of cure cycle in autoclave process.

Role of Tool-Part Interaction in Consolidation of L-Shaped Laminates during Autoclave Process

Numerical Study on Effects of Interaction between Rubber Mould and Lay-up on Consolidation of L-shaped Laminates in Autoclave Process

A Model on the Curved Shapes of Unsymmetric Laminates Including Tool-Part Interaction

Process-Induced Deformation of L-Shaped Laminates: Analysis of Tool–Part Interaction

Numerical analysis of parametric effects on consolidation of angle-bended composite laminates

Numerical Simulation on Consolidation and Deformation of L-shaped Composite Laminate in Autoclave Process

Simulation analysis of parametric effects on consolidation ofangle bended composites

Consolidation Simulation of Composite Laminates: Formulation and Validation Verification

Modeling on the Effect of Automated Fiber Placement Induced Gaps in Curved Composite Laminates

Improved Uniform Degree of Multi-Layer Interlaminar Bonding Strength for Composite Laminate

Numerical Simulation Based Process Window for Consolidation of Thermoset Composite Laminates

INTERLAMINAR STRESS ANALYSIS OF COMPOSITE LAMINATES SUBJECTED TO IN-PLANE LOADING

Influence of Process Parameters on the Interlaminar Shear Strength of CF/PEEK Composites In-Situ Consolidated by Laser-Assisted Automated Fiber Placement

Modeling and Optimization of Interlaminar Bond Strength for Composite Tape Winding Process

Finite Element Modeling of Consolidation of Composite Laminates

Experimental and Numerical Study on the Effect of Rubber Mold Configuration on the Compaction of Composite Angle Laminates During Autoclave Processing

Compaction of Laminated Composites: Numerical Simulation and Analysis on Influencing Factors

Numerical and Experimental Study on the Effect of Lay-Up Type and Structural Elements on Thickness Uniformity of L-Shaped Laminates

An Analytical Model on Through-Thickness Stresses and Warpage of Composite Laminates Due to Tool–part Interaction

Numerical Analysis on the Flow–compaction Behavior and the Effect of Interface Permeability in Thick Composite Plates During Autoclave Processing

Pressure Transfer Behaviour of Rubber Mould and the Effects on Consolidation of L-Shape Composite Laminates