Abstract:Hermetic or vacuum packaging to maintain a controllable cavity pressure and low costs are required by many MEMS devices having moving parts. A novel fabrication technology using micro glass cavities for wafer level hermetic MEMS packaging including accelerometer or gyroscope will be presented.The micro cavities were fabricated by a hot-forming process using Pyrex 7740 since its coefficient of thermal expansion is similar to that of silicon as well as its good sealing properties. Firstly shallow cavities were wet etched fast on the surface of a silicon wafer. Then foaming agents were placed in the silicon cavities. After that the cavities were sealed with a glass wafer by anodic bonding. The bonded wafers were then heated up, and the gas released by foaming agents foamed the glass into spherical bubbles according to the cavity pattern in silicon substrate. Finally, the wafer level spherical glass cavities for packaging MEMS devices were acquired by removing the silicon mold.Then the glass cavities were used to package MEMS. The cap wafer is bonded to the host MEMS wafer by a second anodic bonding process at a relatively low temperature. The MEMS structures were protected by the glass cavities as well as providing a transparent optical window.Mechanical shock test results show that the sealed glass cavities could sustain impact of 30000g acceleration velocity without fracture. LDV test show that the glass cavities could also provide optical window for MEMS devices. The leakage rate of each sealed chamber was tested with He mass spectrometer leak detector, the result show that the leakage rate of the packaged cavity is below 5X 10(-9) Pa. m / s. The impact test was also did by a bounce table which show that the packaged cavity with the side length of about 3 mm can sustain over 30000g acceleration velocity.The novel package technology has a potential application in optical MEMS and Bio-MEMS.

Wafer Level Vacuum Packaging For Mems Device By Solder Sealing

MEMS vacuum packaging technology and applications

A Novel Wafer Level Hermetic Packaging For Mems Devices Using Micro Glass Cavities Fabricated By A Hot Forming Process

High Vacuum Packaging of MEMS Devices Containing Heterogeneous Discrete Components

Chip Level Packaging for Mems Using Silicon Cap

Design and Fabrication of High Performance Wafer-Level Vacuum Packaging Based on Glass–silicon–glass Bonding Techniques

Investigation of MEMS Vacuum Packaging Based on Fusion Welding

Processes Study Of Mems Vacuum Packaging Using Resistance Spot Welding

A low temperature, non-aggressive wafer level hermetic package with UV cured SU8 bond

Implementation of Various Vacuum Conditions in Sealed Chambers for Wafer-Level Bonding by Using Embedded Cavity

Research on vacuum packaging process, equipment and vacuum degree detection of MEMS devices

Wafer Level Vacuum Packaging of MEMS-Based Uncooled Infrared Sensors

Novel Bonding technologies for wafer-level transparent packaging of MOEMS

Wafer-Level Packaging Method For Rf Mems Applications Using Pre-Patterned Bcb Polymer

Low cost fabrication of micro glass cavities for MEMS wafer level and hermetic packaging

A strategy of wafer-level-plastic-packaging for MEMS based on adhesive bonding

Three Dimensional Wafer-level Vacuum Packaging of MEMS Resonant Accelerometer

AnodicBonding StudyonVacuumMicroSealing Cavity

Study on Au-Si Bonding of Wafer Level MEMS Vacuum Packaging

Hot-forming of micro glass cavities for MEMS wafer level hermetic packaging