Abstract:This study aims at establishing a model for close-contact melting (CCM) of shear-thinning fluids. We presented a theoretical framework for predicting the variation of liquid melt film thickness and motion of unmelted solid for both Carreau and power-law fluids. We identified the appropriate energy equation considering the convective effect and derived an analytical temperature profile across the liquid film. Using the lubrication approximation, force equilibrium relationships and the corresponding numerical approaches were built. By using laser interferometry and photographic recording methods, we found excellent agreement between numerical solutions and experimental results for Carreau liquids, revealing that the convective effect weakens heat transfer and melting rate. We identified the critical liquid film thickness that determines three situations of CCM in the theoretical model for Carreau fluids. Numerical prediction demonstrated that the CCM of Carreau fluids can be almost equivalent to that of power-law fluids if the initial film thickness is greater than the critical value. Finally, approximate analytical models were developed for both Carreau and power-law models. For the applicability of the approximate analytical solutions, we derived two-and three-dimensional dimensionless phase diagrams of validity range and identified a key dimensionless group (?Re)Re-4/3 [3 ln(Ste + 1)](1/3) Pe(-1/3), where ? is dimensionless characteristic time, Re is Reynolds number, Ste is Stefan number and Pe is Peclect number. The reliability of the approximate solutions was verified by comparing with the numerical results. These approximate solutions enable convenient and low-cost computational prediction of the dynamic CCM process of shear-thinning fluids.

Effects of Rheological Model on Elastohydrodynamic Film Thickness for Shear--thinning Lubricants

Close-contact Melting of Shear-Thinning Fluids

A Thermal EHL Model for Finite Line Contact with Non-Newtonian Fluids

A Film Thickness Correction Formula for Double-Newtonian Shear-Thinning in Rolling EHL Circular Contacts

EHL Performance of the Lubricant with Shear Strength: Part I — Boundary Slippage and Film Failure

A Lubrication Deviation From the Classical EHL Theory by the Lubricant Viscoplasticity: Part I - Film Thickness Dependence

Influence of Shear-thinning Effect on the Characteristics of Journal Film Bearing

Effects of a typical shear dependent viscosity on analytical elastohydrodynamic lubrication film thickness predictions: A critical issue for the classical approach

Elastohydrodynamic Film Thickness in Elliptical Contacts with Spinning and Rolling

A unified shear-thinning treatment of both film thickness and traction in EHD

About the Load-Carrying Capacity of Elastohydrodynamic Lubrication Film

A Dynamic Rheological Model for Thin-Film Lubrication

Influence of Thermal Effects on Elastohydrodynamic (EHD) Lubrication Behavior at High Speeds

The Effect of the Electric Double Layer on Very Thin Thermal Elastohydrodynamic Lubricating Film

Effects of differential scheme and viscosity model on rough-surface point-contact isothermal EHL

Effect of Thermal Properties of A Coated Elastohydrodynamic Lubrication Line Contact under Various Slide-To-Roll Ratios

Effects of Differential Scheme and Mesh Density on EHL Film Thickness in Point Contacts

EHL Film Thickness Limitation Theory Under a Limiting Shear Stress

Evaluation of Various Shear-Thinning Models for Squalane Using Traction Measurements, TEHD and NEMD Simulations

An Analysis of Elastohydrodynamic Lubrication with Limiting Shear Stress: Part I—Theory and Solutions

Model of fluid–structure interaction and its application to elastohydrodynamic lubrication