Abstract:This study aims at establishing a model for close-contact melting (CCM) of shear-thinning fluids. We presented a theoretical framework for predicting the variation of liquid melt film thickness and motion of unmelted solid for both Carreau and power-law fluids. We identified the appropriate energy equation considering the convective effect and derived an analytical temperature profile across the liquid film. Using the lubrication approximation, force equilibrium relationships and the corresponding numerical approaches were built. By using laser interferometry and photographic recording methods, we found excellent agreement between numerical solutions and experimental results for Carreau liquids, revealing that the convective effect weakens heat transfer and melting rate. We identified the critical liquid film thickness that determines three situations of CCM in the theoretical model for Carreau fluids. Numerical prediction demonstrated that the CCM of Carreau fluids can be almost equivalent to that of power-law fluids if the initial film thickness is greater than the critical value. Finally, approximate analytical models were developed for both Carreau and power-law models. For the applicability of the approximate analytical solutions, we derived two-and three-dimensional dimensionless phase diagrams of validity range and identified a key dimensionless group (?Re)Re-4/3 [3 ln(Ste + 1)](1/3) Pe(-1/3), where ? is dimensionless characteristic time, Re is Reynolds number, Ste is Stefan number and Pe is Peclect number. The reliability of the approximate solutions was verified by comparing with the numerical results. These approximate solutions enable convenient and low-cost computational prediction of the dynamic CCM process of shear-thinning fluids.

A Thermal EHL Model for Finite Line Contact with Non-Newtonian Fluids

A Thermal Equilibrium Analysis of Line Contact Hydrodynamic Lubrication Considering the Influences of Reynolds Number, Load and Temperature

EHL Properties of Roller Contacts and Its Application Part Ⅱ: A Numerical Analysis of EHL for Engineering Logarithmic Roller

Close-contact Melting of Shear-Thinning Fluids

A Study on Heat Transfer Model for the Dynamic Contact Boundary Between Piston Ring and Cylinder Liner

Comparisons of TEHL Simulations of Newtonian Fluids in Line Contacts Between the 3D FEM and the Reynolds Equation–Based Approaches*

Thermal mixed elastohydrodynamic lubrication modeling and analysis of the lubricated non-conformal contacts with non-Gaussian surface roughness and coating

A thermal model in frictional contacts

Thermal Non-Newtonian EHL Analysis of Rib-Roller End Contact in Tapered Roller Bearings

A fast calculation approach for elastohydrodynamic finite line contacts applicable to online calculations of rolling bearing models

Effects of Texture Orientation on the Mixed Thermal Elastohydrodynamic Lubrication and Fatigue Life in Point Contacts

EHL Performance of the Lubricant with Shear Strength: Part I — Boundary Slippage and Film Failure

Influence of Thermal Effects on Elastohydrodynamic (EHD) Lubrication Behavior at High Speeds

Elastohydrodynamic Film Thickness in Elliptical Contacts with Spinning and Rolling

Effects of differential scheme and viscosity model on rough-surface point-contact isothermal EHL

A Computer Thermal Model of Mixed Lubrication in Point Contacts

Predicting Fatigue Life for Finite Line Contact under Starved Elastohydrodynamic Lubrication Condition

A Mixed Elastohydrodynamic Lubrication Model With Asperity Contact

Effects of boundary slips on thermal elastohydrodynamic lubrication under pure rolling and opposite sliding contacts

A fully coupled finite element solution for the mixed elastohydrodynamic lubrication of finite line contacts

EHL Film Thickness Limitation Theory Under a Limiting Shear Stress