Microstructural Evolution and Mechanical Properties of the Joint of TiAl Alloys and C/SiC Composites Vacuum Brazed with Ag–Cu Filler Metal

Zhenwen Yang,Peng He,Lixia Zhang,Jicai Feng

DOI: https://doi.org/10.1016/j.matchar.2011.05.007

IF: 4.537

2011-01-01

Materials Characterization

Abstract:Microstructural evolution and shear strength of vacuum brazed TiAl alloys to C/SiC composites using Ag–Cu filler metal were investigated. The dissolution of active elements Ti and Al from TiAl substrate has a strong influence on the microstructure and shear strength of the joint. Ag is the less active element of the filler and Cu has strong tendency to the formation of AlCu2Ti phase with the dissolved Ti and Al. Ag–Cu eutectic is gradually taken place by AlCu2Ti blocks and Ag-based solid solution with the increase of brazing temperature or time. The TiC reaction layer including a small amount of Ti5Si3 phase is formed adjacent to C/SiC composites when active element Ti diffused into C/SiC composite and chemical reaction occurred in the composite interface. The shear strength of the joint depends heavily on the thickness of the TiC reaction layer. The maximum shear strength achieved 85MPa for the joint vacuum brazed at 900°C for 10min. Cracks primarily propagate along Ag-rich phase and TiC layer. The TiC layer with the thickness of 4–5μm is formed at the boundary of SiC matrix.