Abstract:NiO nanomaterials prepared using a solid–liquid NH3·H2O precipitation method (NiO-NSL) were tested in the catalytic combustion of methane. The NiO-NSL presented a characteristic rod-like nanostructure with a length of about a few hundred nanometers except for a part of the nanoparticles. For comparison, the NiO nanomaterials prepared by the traditional liquid-phase NH3·H2O precipitation method (NiO-NLL) were tested in the same reaction conditions. NiO-NSL exhibited significantly higher methane combustion activity than NiO-NLL and achieved the complete combustion of methane at 390 °C, which was outstanding in non-noble metal-based catalyst. X-ray photoelectron spectroscopy (XPS) and hydrogen-temperature-programmed reduction (H2-TPR) results indicate that the surface Ni2+ content of NiO-NSL was higher than that of NiO-NLL, and the presence of more Ni2+ might be responsible for the enhanced activity. DFT calculations prove that the energy barrier for C–H bond activation on Ni2+ was lower than that on Ni3+, which was consistent with the higher methane catalytic combustion activity of NiO-NSL. In addition, when the precipitating agent was replaced with NaOH and (NH4)2CO3, the generalization of the solid–liquid precipitation method in the preparation of the NiO catalysts was also tested. The results show that the solid–liquid precipitation method proposed in this work was still applicable when NaOH was used as a precipitant. However, with the use of (NH4)2CO3 as a precipitant, the methane catalytic activity of the NiO nanoparticles prepared by the solid–liquid precipitation method was reduced to a certain extent compared with the traditional liquid-phase precipitation method. This research can open up a highly efficient and environmentally friendly method for the synthesis of methane combustion catalysts.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.1c00732?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.1c00732</a>.Stability test results of NiO-NSL (Figure S1); wide-angle XRD patterns of the as-precipitated samples using (NH4)2CO3 as the precipitant and a standard xNiCO3·yNi(OH)2 sample (Figure S2); representative TEM images of the precursors and as-calcined catalysts of the other four samples (Figures S3 and S4); specific performance data of samples in previous research (Table S1); XPS analysis of the other samples (Table S2, Figures S5 and S6); H2-TPR profiles of the other samples (Table S3, Figures S7 and S8); detailed DFT calculation results (Table S4); the surface model used in the calculations (Figure S9) (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.1c00732/suppl_file/an1c00732_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Properties of Ni/Y2O3 and Its Catalytic Performance in Methane Conversion to Syngas

Methane conversion to syngas over Ni/Y2O3 catalysts - Effects of calcination temperatures of Y2O3 on physicochemical properties and catalytic performance

Effect of support texture properties on Ni-Fe/γ-Al_2O_3 catalyst structure and catalytic performance for CO methanation

Partial Oxidation Of Methane To Syngas Over Ni-Based Catalysts

Catalytic Partial Oxidation of Methane to Syngas over Ca-Decorated-Al2o3-Supported Ni and Nib Catalysts

Study on Methanation Performance of Biomass Gasification Syngas Based on a Ni/Al2O3 Monolithic Catalyst

Investigation on the Performance of Supported Molybdenum Carbide for the Partial Oxidation of Methane

Recent Progress on Ni-Based Catalysts in Partial Oxidation of Methane to Syngas

Partial oxidation of methane to syngas over Ni/Al2O3 catalysts prepared by a modified sol-gel method

Partial Oxidation of Methane to Syngas Over Nickel-Based Catalysts: Influence of Support Type, Addition of Rhodium, and Preparation Method

Partial Oxidation of Bio-methane over Nickel Supported on MgO-ZrO2 Solid Solutions

Physicochemical properties of Ni/γ-Al2O3-AlN and effects of AlN on catalytic performance of Ni/γ-Al2O 3-AlN in partial oxidation of methane

Effect of Ni Loading and Reaction Conditions on Partial Oxidation of Methane to Syngas

Catalytic Hydropyrolysis of Lignin Using NiMo-doped Catalysts: Catalyst Evaluation and Mechanism Analysis

Partial Oxidation of Methane Over NiOx/Hierachichal ZSM-5 Catalyst

Studies on the Performance and Structure of Supported Catalysts for the Partial Oxidation of Methane to Syngas

Promoted Ni Catalyst Over Titania-Zirconia Support for Partial Oxidation of Methane: Simple and Practical Catalysts

Atomically dispersed MoNi alloy catalyst for partial oxidation of methane

Irregularly Shaped NiO Nanostructures for Catalytic Lean Methane Combustion

Catalytic Methanation of Syngas over Ni-based Catalysts with Different Supports

Investigating the Effect of Ni Loading on the Performance of Yttria-Stabilised Zirconia Supported Ni Catalyst during CO2 Methanation