Abstract:New time-based readout (TBR) electronics has been developed and evaluated for its performance and application for PET detectors. It consists of a leading edge (LE) timing threshold for timing pickoff that provides a signal timing t1; a charge integration followed by a constant discharge between two specific timings t2 and t3 that are used to directly measure the signal energy. The timing-walk error caused by LE from signals of different amplitudes can be measured with t1 as a function of different signal amplitudes that is proportional to the time difference between t2 and t3. With this pre-calibration, timing-walk error can be accurately corrected. Therefore, both signal timing and energy can be accurately measured with digital timing signals without using CFD and ADC. These timing signals were controlled and in principle can be measured by an FPGA that can apply many signal logic and data correction algorithms. A single channel discrete component TBR circuit has been implemented in PC board, and 8-channel ASIC chips have been developed for feasibility evaluations and PET detector applications. Initial functionality and performance evaluations have been conducted. Signal amplitude measurement accuracy and linearity are very good; the measured timing accuracy from a pulse is the same as a standard CFD and reaches to similar to 100 ps resolution with the test setup. Both suitable energy and coincidence timing resolutions (similar to 17% and similar to 1.0-2.0 ns) were achieved with PMT or Solid-State PM (SSPM) array based PET detectors. Initial studies to acquire flood source crystal identification map has demonstrated the advantages of applying parallel readout with TBR electronics that read out and process signals from each pixel of SSPM array independently. With its relatively simple circuit and low cost, TBR electronics is expected to provide suitable front-end signal readout electronics for compact photon detectors such as SSPM array that require large number of output channels and demand high performance in energy and timing.

Fpga Based Electronics For Pet Detector Modules With Neural Network Position Estimators

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

Design and evaluation of a FPGA-ADC prototype for the PET detector based on LYSO Crystals and SiPM arrays

Readout Electronics Development Based on an ASIC for PET Detector Using PMT-quadrant-sharing

Design And Initial Performance Evaluation Of A Novel Pet Detector Module Based On Compact Sipm Arrays

A compact and highly integrated 128-channel FPGA-based readout electronics for nuclear imaging application

Design And Development Of Novel And Practical Pet Detectors For Advanced Imaging Applications

An FPGA Based energy correction method for one-to-one coupled PET detector: model and evaluation

Development Of Multi-Channel Fast Sipm Readout Electronics For Clinical Tof Pet Detector

A Novel Sub-Millimeter Resolution Pet Detector with Tof Capability

The design of a time-interleaved analog-digital conversion modulator based on FPGA-TDC for PET application

Development of a MR-compatible DOI-TOF detector module for PET imaging systems

Real-Time FPGA-based Digital Signal Processing and Correction for a Small Animal PET

Energy And Timing Measurement Of A Pet Detector With Time-Based Readout Electronics

3D Positioning and Readout Channel Number Compression Methods for Monolithic PET Detector

Front-End Electronics Design Based on Vernier Method for A High Resolution Micropet

Evaluation of a Prototype of New Position-Sensitive Detector for a Small Animal PET System

A Design of FPGA Based Small Animal PET Real Time Digital Signal Processing and Correction Logic

A multi-functional front end readout electronics system for PET detector application

DESIGN OF A NEW DEPTH ENCODING DETECTOR FOR PET

Development of the front-end electronics for a cost-effective PET-like detector system