Abstract:Silicon photomultipliers (SiPM) are rapidly adapted in simultaneous time of flight (TOF) PET and MRI imaging system in recent years due to its fast timing response and immunity to magnetic field. The aim of this work is to develop multi-channel fast SiPM readout electronics for clinical TOF PET detector. The detector module is assembled by directly coupling a 12x12 LYSO crystal block to an 8x8 Sensl FB30035 SiPM array. We are developing two approaches of compact readout electronics to handle the large number of SiPM output channels. One is a low noise and high bandwidth, 128-channel ASIC to readout the 64 fast outputs and 64 standard outputs of the 8x8 SiPM array. The other approach is a conventional electronics based multiplexing readout scheme using discrete components. A charge division resistor network reduced 64 channels of standard output to four energy signals, and multiplexing and summing circuits reduced 64 channels of fast output to one timing signal, making the detector block highly compact and scalable. The ASIC design has been finished and it's ready for tape-out. Preliminary performance of the detector module readout by conventional electronics was evaluated. 12x12 LYSO crystals were well resolved and identified in the flood image and the average energy resolution was 15.6% +/- 1.3%. For single crystal pair, 240ps coincidence resolving timing (CRT) was achieved. It was dropped down to 500ps for detector block to single crystal configuration, due to the combination effects of: 1) degradation of fast signal rising edge by output capacitance addition of SiPMs and 2) large white electronic noise and ultrahigh dark count rate. The readout design will be further optimized by increasing the signal bandwidth and reducing noise to get better timing performance at a cost of increasing circuit complexity to a reasonable level. The performance of ASIC readout will be evaluated and good timing performance is expected due to the individual pixel timing pick-off.

An FPGA Based energy correction method for one-to-one coupled PET detector: model and evaluation

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

Design and evaluation of a FPGA-ADC prototype for the PET detector based on LYSO Crystals and SiPM arrays

Design and preliminary performance of a novel mixed-signal front-end electronics with post digital shaping for CZT detectors

Evaluation of a PET detector based on SiPMs and FPGA-only MVT digitizers

A compact and highly integrated 128-channel FPGA-based readout electronics for nuclear imaging application

Electronics for monolithic scintillator PET detector modules based on neural network position estimators

Fpga Based Electronics For Pet Detector Modules With Neural Network Position Estimators

Development of a Compact and Cost-Effective PET Detector Module for a Small-Animal PET System with FESA ASIC

Development Of Multi-Channel Fast Sipm Readout Electronics For Clinical Tof Pet Detector

Real-Time FPGA-based Digital Signal Processing and Correction for a Small Animal PET

An FPGA-based Time Sampling Charge Measurement Method for TOF-PET Detectors

An FPGA-Based Real-Time Maximum Likelihood 3D Position Estimation for a Continuous Crystal PET Detector

An FPGA Charge-to-Digital Converter Based on Voltage-Referenced Receivers for PET Applications

An Analog Front-end ASIC Design for 16-Channel SiPM Readout in PET Detectors

Energy Calibration Using Scintillator Background Radiation for High-Resolution PET Detectors

A Novel Front-End Electronic System with Full-Customized Readout ASIC and Post Digital Pulse Shaping for CZT-based PET Imaging

An FPGA-Based Fast Linear Discharge Readout Scheme Enabling Simultaneous Time and Energy Measurements for TOF-PET Detectors

Investigation of analog charge multiplexing schemes for SiPM based PET block detectors.

Dual threshold input receiver FPGA-only signal digitization method for time-of-flight positron emission tomography

An FPGA-Based 64-Channel Readout Electronics for High-Resolution TOF-PET Detectors