Abstract:The effect of bed pressure drop and bed inventory on the performances of a circulating fluidized bed (CFB) boiler was studied. By using the state specification design theory, the fluidization state of the gas-solids flow in the furnace of conventional CFB boilers was reconstructed to operate at a much lower bed pressure drop by reducing bed inventory and control bed quality. Through theoretical analysis, it was suggested that there would exist a theoretical optimal value of bed pressure drop, around which the boiler operation can achieve the maximal combustion efficiency and with significant reduction of the wear of the heating surface and fan energy consumption. The analysis was validated by field tests carried out in a 75 t/h CFB boiler. At full boiler load, when bed pressure drop was reduced from 7.3 to 3.2 kPa, the height of the dense zone in the lower furnace decreased, but the solid suspension density profile in the upper furnace and solid flow rate were barely influenced. Consequently, the average heat transfer coefficient in the furnace was kept nearly the same and the furnace temperature increment was less than 17 degrees C. It was also found that the carbon content in the fly ash decreased first with decreasing bed pressure drop and then increased with further increasing bed pressure drop. The turning point with minimal carbon content was referred to as the point with optimal bed pressure drop. For this boiler, at the optimum point the bed pressure was around 5.7 kPa with the overall excess air ratio of 1.06. When the boiler was operated around this optimal point, not only the combustion efficiency was improved, but also fan energy consumption and wear of heating surface were reduced.

Experimental study of the bed Inventory overturn in pant-legs furnace of CFB boiler

Bed-inventory overturn mechanism for pant-leg circulating fluidized bed boilers

Bed Inventory Overturn in A Circulating Fluid Bed Riser with Pant-Leg Structure

The Mechanism of Lateral Solid Transfer in a CFB Riser with Pant-Leg Structure

Experimental research on solids oscillation circulation behavior in circulating fluidized bed

Impacts of Bed Inventory and Air Distributor Resistance on Bed Overturn in Circulating Fluidized Bed with Pant-legs

Mechanism of the Impact of Particle Size Distribution to Bed-Inventory Overturn for Pant-Leg Circulating Fluidized Bed

Experimental Investigation of the Scaling-Off Location and the Slag Mass in Pulverized Coal-Fired Boiler with Water-Cooled Slag Removal

Wobble Mechanism of Pressure Drop in Furnace of a Large Scale CFB Boiler

Mechanism Analysis of Gas Solid Flow Non-Uniformity Problem of 330 MW CFB Boiler

Modeling Study on Non‐Uniform Lateral Distribution in Large‐Scale Circulating Fluidized Bed Boilers

Bed Inventory Balance and Stability of Dual Circulating Fluidized Bed Systems

Effect of Bed Pressure Drop on Performance of A Cfb Boiler

Influence of the Coal Feed on the Bed Temperature Uniformity of a Large-sized CFB Boiler

Experimental Study on Gas-Solid Flow Charcteristics in a CFB Riser of 54M in Height

Combustion Test by Changing Bed Inventory on Circulating Fluidized Bed Boiler

Mechanism Study of Lateral Bed Pressure Wave of Large Scale CFB Boilers

Active Disturbance Rejection Control for Bed-inventory Balancing of CFB Boilers with Pant-leg Structure

Effects of Riser Height and Total Solids Inventory on the Gas–solids in an Ultra-Tall CFB Riser

Numerical Simulation of the Bed Material Unbalance Between the Breeches-legs in a Circulating Fluidized Bed Boiler

Study on the dynamic balance behaviors of bed material during the start-up process of a circulating fluidized bed boiler