Abstract:A novel Rayleigh Doppler lidar technology based on a quadruple dual-pass Fabry–Perot interferometer (FPI) that can accurately measure wind field, temperature and aerosol backscatter ratio from the troposphere to lower stratosphere is proposed. This study aims to analyse the detection principle of wind speed, temperature and aerosol backscatter ratio in detail and obtain their measurement error formulas. The structure of this type of lidar is studied and designed. The FPI consists of two edge channels FPI-1 and FPI-2, aerosol channel FPI-M and locking channel FPI-L. FPI-1, FPI-2 and FPI-M use a dual-pass optical path, whereas FPI-L uses a single-pass optical path. The parameters of FPI are optimised as follows: the free spectral spacing (FSR) is 12 GHz, the FWHM of FPI-1 and FPI-2 are both 2.2 GHz, the peak-to-peak interval of FPI-1 and FPI-2 is 5.8 GHz, the FWHM of FPI-M and FPI-L are both 1.2 GHz, the peak-to-peak interval of FPI-M and FPI-1 is 2.9 GHz and the peak-to-peak interval of FPI-L and FPI-1 is 2.3 GHz. Under simulated atmospheric conditions, for a daytime sky background brightness of 0.3 Wsr −1 m −2 nm −1 at 355 nm, using a laser with a pulse energy of 350 mJ and a repetition frequency of 50 Hz and a telescope with a 0.45-m aperture, with a vertical range resolution of 30 m at 0–10 km, 100 m at 10–20 km and 500 m at 20–35km, temporal resolution of 30 min, zenith angle of 0° for temperature and aerosol backscatter ratio detection and temporal resolution of 3 min and zenith angle of 30° for radial wind speed detection, the detection performance of the designed Rayleigh Doppler lidar is determined. The simulation results show that the measurement errors of aerosol backscatter ratio, temperature and radial wind speed of the lidar system in the daytime and night-time are less than 4.36 × 10 −3 and 3.32 × 10 −3 (excluding cirrus cloud area), 4.0 K and 3.0 K and 3.8 m/s and 1.9 m/s, respectively, from an altitude of 0.06 to 35km.

Assessment Of A(1) Three-Frequency Alternate Pulse Doppler Wind Lidar

Low-altitude atmospheric wind measurement from the combined Mie and Rayleigh backscattering by Doppler lidar with an iodine filter

1.55Μm All-Fiber Coherent Doppler Lidar for Wind Measurement

Performance of Continuous-wave Coherent Doppler Lidar for Wind Measurement

Incoherent Doppler Lidar System Using Differential Discrimination Technique for Tropospheric Wind Measurement

Low-Altitude Wind Measurement Using Incoherent Doppler Lidar by Utilizing Both Absorption Slopes of the Iodine Absorption Spectrum

Doppler Wind Lidar Based on Fabry-Perot Etalon

Fabry-Perot interferometer based Mie Doppler lidar for low tropospheric wind observation

A novel wind ladar system based on 1.55 mu m All-fiber Coherent

Performance validation for wind measurement with multi-longitudinal mode double-edge detection

Beam Scanning and Wind Field Measurement of Direct-Detection Doppler Lidar

Analysis on wind retrieval methods for Rayleigh Doppler lidar

Design of Verifying Attachment for Calibration of Wind Lidar

Enhanced Wind-Field Detection Using an Adaptive Noise-Reduction Peak-Retrieval (ANRPR) Algorithm for Coherent Doppler Lidar

Pulse Accumulation Approach Based on Signal Phase Estimation for Doppler Wind Lidar

A Novel Wind Ladar System Based on 1.55μm All-Fiber Coherent Doppler Laser

Scanning Rayleigh Doppler Lidar for Wind Profiling Based on Non-polarized Beam Splitter Cube Optically Contacted FPI

Quad-Fabry-Perot etalon based Rayleigh Doppler lidar for 0.2-60km altitude wind, temperature and aerosol accurate measurement

Rayleigh Doppler Lidar Technology Based on a Quadruple Dual-pass Fabry–Perot Interferometer

Performance analysis of dual-frequency lidar in the detection of the complex wind field