Abstract:A novel Rayleigh Doppler lidar technology based on a quadruple dual-pass Fabry–Perot interferometer (FPI) that can accurately measure wind field, temperature and aerosol backscatter ratio from the troposphere to lower stratosphere is proposed. This study aims to analyse the detection principle of wind speed, temperature and aerosol backscatter ratio in detail and obtain their measurement error formulas. The structure of this type of lidar is studied and designed. The FPI consists of two edge channels FPI-1 and FPI-2, aerosol channel FPI-M and locking channel FPI-L. FPI-1, FPI-2 and FPI-M use a dual-pass optical path, whereas FPI-L uses a single-pass optical path. The parameters of FPI are optimised as follows: the free spectral spacing (FSR) is 12 GHz, the FWHM of FPI-1 and FPI-2 are both 2.2 GHz, the peak-to-peak interval of FPI-1 and FPI-2 is 5.8 GHz, the FWHM of FPI-M and FPI-L are both 1.2 GHz, the peak-to-peak interval of FPI-M and FPI-1 is 2.9 GHz and the peak-to-peak interval of FPI-L and FPI-1 is 2.3 GHz. Under simulated atmospheric conditions, for a daytime sky background brightness of 0.3 Wsr −1 m −2 nm −1 at 355 nm, using a laser with a pulse energy of 350 mJ and a repetition frequency of 50 Hz and a telescope with a 0.45-m aperture, with a vertical range resolution of 30 m at 0–10 km, 100 m at 10–20 km and 500 m at 20–35km, temporal resolution of 30 min, zenith angle of 0° for temperature and aerosol backscatter ratio detection and temporal resolution of 3 min and zenith angle of 30° for radial wind speed detection, the detection performance of the designed Rayleigh Doppler lidar is determined. The simulation results show that the measurement errors of aerosol backscatter ratio, temperature and radial wind speed of the lidar system in the daytime and night-time are less than 4.36 × 10 −3 and 3.32 × 10 −3 (excluding cirrus cloud area), 4.0 K and 3.0 K and 3.8 m/s and 1.9 m/s, respectively, from an altitude of 0.06 to 35km.

Beam Scanning and Wind Field Measurement of Direct-Detection Doppler Lidar

Analysis of data processing method for Doppler wind lidar

Detection of Atmospheric Boundary Layer Height in the Plum Rain Season over Hangzhou Area with Three-Dimensional Scanning Polarized Lidar

Multi-Longitudinal-Mode High-Spectral-Resolution Lidar

Analysis of Errors Induced by Angle Tuning in Direct Detection Doppler Wind Lidar

Doppler Wind Lidar Based on Fabry-Perot Etalon

Retrieving the Seawater Volume Scattering Function at the 180° Scattering Angle with a High-Spectral-resolution Lidar

Data Processing and Analysis of Eight-Beam Wind Profile Coherent Wind Measurement Lidar

Direct Detection Doppler Wind Lidar Based on Dual FP Etalon

1.55Μm All-Fiber Coherent Doppler Lidar for Wind Measurement

Rayleigh Doppler Lidar Technology Based on a Quadruple Dual-pass Fabry–Perot Interferometer

Scanning Rayleigh Doppler Lidar for Wind Profiling Based on Non-polarized Beam Splitter Cube Optically Contacted FPI

Mobile Rayleigh Doppler lidar for wind and temperature measurements in the stratosphere and lower mesosphere

Evaluation and Wind Field Detection of Airborne Doppler Wind Lidar with Automatic Intelligent Processing in North China

Inter-comparison study of wind measurement between the three-lidar-based virtual tower and four lidars using VAD techniques

Comprehensive wind correction for a Rayleigh Doppler lidar from atmospheric temperature and pressure influences and Mie contamination

Performance of Continuous-wave Coherent Doppler Lidar for Wind Measurement

Quad-Fabry-Perot etalon based Rayleigh Doppler lidar for 0.2-60km altitude wind, temperature and aerosol accurate measurement

Analysis on wind retrieval methods for Rayleigh Doppler lidar

Incoherent Doppler Lidar System Using Differential Discrimination Technique for Tropospheric Wind Measurement

Multilevel Validation of Doppler Wind Lidar by the 325 m Meteorological Tower in the Planetary Boundary Layer of Beijing