Abstract:A high precision electrostatic accelerometer has widely been employed to measure gravity gradients and detect gravitational waves in space. The high-voltage levitation method is one of the solutions for testing electrostatic accelerometers on the ground, which aims at simultaneously detecting all six-degree-of-freedom movements of the electrostatic accelerometers engineering and flight prototypes. However, the noise performance in the high-voltage levitation test is mainly limited by seismic noise. The combined test of the accelerometer and vibration isolation platform is adopted to improve the detection precision of the high-voltage levitation method. In this paper, a high precision electrostatic accelerometer prototype is developed after designed appropriate mechanical parameters with a test mass weighing 300 g and with an estimated resolution of 2 × 10-12 m/s2/Hz1/2 from 0.01 to 0.4 Hz. Such a prototype is tested by the high-voltage levitation method, its measurement noise on the ground is mainly limited by the seismic noise, which is about 5 × 10-7 m/s2/Hz1/2 around 0.2 Hz and about 4 × 10-8 m/s2/Hz1/2 around 0.1 Hz. A vibration isolation pendulum bench based on the translation-tilt compensation principle is adopted for accelerometer prototype combined tests to suppress the seismic noise, which has a large bench area and the ability to adjust the tilt angle precisely. The measured accelerometer noise of the combined test with the translation-tilt compensation pendulum has reached 3 × 10-9 m/s2/Hz1/2 around 0.2 Hz, and it is about two orders of magnitude lower than the measurement noise on the ground. The combined test method provides technical guidance for further improving the noise level of ground test in the future.

A New Method to Eliminate the Noise of Vacuum Microelectronic High Precision Accelerometer

Analysis of the Frequency-Dependent Vibration Rectification Error in Area-Variation-Based Capacitive MEMS Accelerometers.

Noise Behaviors of a Closed-Loop Micro-Electromechanical System Capacitive Accelerometer

Micromachined Accelerometers with Sub-µg/√Hz Noise Floor: A Review

Micromachined Accelerometers with Sub-g/Hz Noise Floor: A Review

A Novel Low Noise Interface ASIC of Vacuum Microelectronic Accelerometer

The Modulation and Demodulation Module of a High Resolution MOEMS Accelerometer

Synthesis of the System Modeling and Signal Detecting Circuit of a Novel Vacuum Microelectronic Accelerometer

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

Noise Analysis and Parameter Optimization of Digital MEMS Accelerometer System

A Novel Integrated High Precision Vacuum Microelectronic Accelerometer

Noise Investigation of an Electrostatic Accelerometer by a High-Voltage Levitation Method Combined with a Translation-Tilt Compensation Pendulum Bench

High-G MEMS Accelerometer Calibration Denoising Method Based on EMD and Time-Frequency Peak Filtering

Low Noise Vacuum MEMS Closed-Loop Accelerometer Using Sixth-Order Multi-Feedback Loops and Local Resonator Sigma Delta Modulator

A Novel, Hybrid-Integrated, High-Precision, Vacuum Microelectronic Accelerometer with Nano-Field Emission Tips.

Micromachined Accelerometers with Sub-μg/√Hz Noise Floor: A Review

Noise Analysis and Performance Improvement of a MEMS Fabry-Pérot Seismic Accelerometer

Design and Modification of a High-Resolution Optical Interferometer Accelerometer

Nano-g accelerometer with differential Fabry-Perot interferometer for low-frequency noise suppression

High-precision and low-cost vibration generator for low-frequency calibration system

A New High-Precision Micro-Accelerometer Based on Optomechanical System