Abstract:The strain after rolling plays an important role in the prediction of the microstructure and properties and plate deformation permeability. So, it is necessary to establish a more accurate theoretical strain model for the rolling process. This paper studies the modeling method of the equivalent strain based on the upper bound principle and the stream function method. The rolling deformation region is divided into three zones (inlet rigid zone, plastic zone, and outlet rigid zone) according to the kinematics. The boundary conditions of adjacent deformation zones are modified according to the characteristics of each deformation zone. A near-real kinematics admissible velocity field is established by the stream function method on this basis. The geometric boundary conditions of the deformation region are obtained. The deformation power, friction power, and velocity discontinuous power are calculated according to the redefined geometric boundary conditions. On this basis, the generalized shear strain rate intensity is calculated according to the minimum energy principle. Finally, the equivalent strain model after rolling is obtained by integrating the generalized shear strain rate in time. The plate rolling experiments of AA1060 and the numerical simulations are carried out with different rolling reductions to verify the analytic model precision of the equivalent strain. The results show that the minimum and the maximum relative equivalent strain deviation between the analytic model and the experiment is 0.52% and 9.96%, respectively. The numerical calculation and experimental results show that the model can accurately calculate the strain along the plate thickness. This model can provide an important reference for the rolling process setup and the microstructure and properties prediction.

Research on the Influence of Single Roll Adjusting to the Plate Straightening Quality

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

ANALYSIS AND MODIFICATION OF HYDRAULIC ROLLER BENDING FORCE CONTROL SYSTEM

Analysis of Design of Mandrel Pipe Mill Roll Gap Adjustment System

A 2.5-Dimensional Analytical Model of Cold Leveling for Plates with Transverse Wave Defects

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

The Causes and Control of Longitudinal Edge Cracks of the Plate

Bending analysis and control of rolled plate during snake hot rolling

Research on the Hot Straightening Process of Medium-Thick Plates Based on Elastic-Viscoplastic Material Modeling

RESEARCH ON THEORETICAL MODEL OF PRESS STRAIGHTENING PROCESS AND ITS EXPERIMENT

Elongation Control of the Ultra-Thin Tinplate During Two-Stand Temper Rolling Unsteady Process

The central strain analytical modeling and analysis for the plate rolling process

Flexible Roll Forming with Staggered Arranged Rollers for the Large Curved Metal Plates Based on Numerical Simulation

Calculation method and analysis of residual stress in the strip bending roller straightening process

The theoretical model of the effective strain establishment for the plate during the snake rolling

Research on key technologies for straightening pocketed aircraft frame parts

The numerical simulation analysis of the straightening process of the large H-shaped steel

A double-layer optimization model for flatness control of cold rolled strip

Research on the Mechanism and Processability of Roll Forming

Design of intermediate roll contour and analysis of regulation ability on strip shape of 18-High mill

Establishment and Application of Load-Deflection Model of Press Straightening