Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Effect of O2 / SO2 Ratio in the Flue Gas on Manganese Extract Process and Byproduct in the Process of Flue Gas Desulfurization with Pyrolusite Pulp

Mechanistic Study on the Enhanced SO2-tolerant Ability of CuCl2-promoted MnOx-CeOx Mixed Oxide for Hg0 Removal

Removal and Resource Utilization of High Concentration Flue Gas Sulfur Dioxide Using Manganese Carbonate Ore

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

Manganese leaching in high concentration flue gas desulfurization process with semi-oxidized manganese ore

Study on optimum technological conditions of ore sintering flue gas desulfurization by using poor manganese

Mechanisms of dry flue-gas desulfurization using natural manganese oxide ores

In-process control of manganese dithionate in the manganese ore-based wet flue gas desulfurization coupled with efficient manganese leaching

Promotion of manganese extraction and flue gas desulfurization with manganese ore by iron in the anodic solution of electrolytic manganese

The Formation of Manganous Dithionate in the Manganese Oxide Flue Gas Desulfurization

Manganese Ore-based Wet Flue-Gas Desulfurization: A Review

Ore sintering flue gas desulfurization and its resoureilization by using pyrolusite

Removal of SO2 from Smelting Flue Gas by Using Copper Tailings with MnSO4: Factors Optimization by Response Surface Methodology

[Inhibition of Sulfite Oxidation Catalyzed by Heavy Metals in Dual Alkali Flue Gas Desulfurization Slurry].

Preparation of Sulfur Dioxide by Divalent Iron Synergistic Coke Reduction of Phosphogypsum in a Fluidized Bed

Simultaneous Removal of SO2 and NO by FeII(EDTA) Solution: Promotion of Mn Powder and Mechanism of Reduction

Mass Transfer and Kinetics Study on the Sulfite Forced Oxidation with Manganese Ion Catalyst

Efficient Removal of Sulfur Dioxide from Flue Gas Through Liquid Catalytic Oxidation Using Copper Tailing As the in Situ Iron Ion Donator

Simultaneous absorption of NOx and SO2 from flue gas with pyrolusite slurry combined with gas-phase oxidation of NO using ozone

O3 oxidation combined with semi-dry method for simultaneous desulfurization and denitrification of sintering/pelletizing flue gas

Mechanistic and thermodynamic insights into the SO2 oxidation on MnO2 catalysts: A combined theoretical and experimental study