Abstract:The mode coupling is a major factor to affect the precision of the micro electromechanical systems（MEMS） gyroscope. Currently, many MEMS gyroscopes with separate oscillation modes for drive and detection have been developed to decrease the mode coupling, but the gyroscope accuracy can not satisfy the high-precision demand well. Therefore, high performance decoupled MEMS gyroscopes is still a hot topic at present. An innovative design scheme for a MEMS gyroscope is designed, and in this design, the inertial mass is divided into three parts including the inner mass, the outer mass and the main frame mass. The masses are supported and separated by a set of mutually orthogonal beams to decouple their movements. Moreover, the design is modelled by multi-port-element network（MuPEN） method and the simulation results show that the mode coupling of the gyroscope between driving and sensing mode was eliminated effectively. Furthermore, we proposed a new silicon-on-insulator（SOI） process to fabricate the gyroscope. The scale factor of the fabricated gyroscope is 8.9 mV/（（o）?s） and the quality factor（Q-factor） is as high as 600 at atmosphere pressure, and then, the resonant frequency, scale factor and bias drift has been test. Process and test results show that the proposed MEMS gyroscope are effective for decrease mode coupling, furthermore, it can achieve a high performance at atmosphere pressure. Furthermore, the MEMS gyroscope can achieve a high performance at atmosphere pressure. The research can be taken as good advice for the design and fabrication of MEMS gyroscope, meanwhile, it also provides technical support for speeding up of MEMS gyroscope industrialization.

Micromachined Inertial Measurement Unit Fabricated by a SOI Process with Selective Roughening under Structures

An Integrated Reduced Micromachined Inertial Measurement Unit for Land Vehicle Navigation

Design, fabrication, and testing of a bulk micromachined inertial measurement unit.

A Monolithic Inertial Measurement Unit Fabricated with Improved DRIE Post-Cmos Process

Process Development of A New Tgv Interposer for Wafer Level Package of Inertial Mems Device

Fabrication of SOI MEMS Inertial Sensors with Dry Releasing Process

Design and calibration of MIMU based on chip size micro inertial sensors

A high sensitivity micromachined accelerometer with an enhanced inertial mass SOI MEMS process

Novel Silicon Cap Package Technology for Monolithic Microinertial Measurement Unit

A single-mask dry-release process for fabrication of high aspect ratio SOI MEMS devices

Single Mask Selective Release Process for Complex SOI MEMS Device

One Single Chip Micro Inertial Measurement Unit

One Bulk Micromachined Single-Chip Inertial Measurement Unit

Design and fabrication of MEMS devices using the integration of MUMPs, trench-refilled molding, DRIE and bulk silicon etching processes

Process Development for CMOS-MEMS Sensors with Robust Electrically Isolated Bulk Silicon Microstructures

Design of Micro Inertial Measurement Unit Based on Micromachined Thermal Expansion Gas Gyroscope

Design and Fabrication of MEMS Gyroscopes on the Silicon-on-insulator Substrate with Decoupled Oscillation Modes

A Wafer Level Vacuum Encapsulated Capacitive Accelerometer Fabricated in an Unmodified Commercial MEMS Process

A Dicing-Free Soi Process for Mems Devices Based on the Lag Effect

Post-CMOS Processing for High-Aspect-Ratio

MEMS-based Micro Inertial Measurement Unit