Abstract:Large-displacement shear appears between pile shaft and its surrounding soil during the penetration process, and cyclic shear is the typical feature in subsequent service load condition. In this paper, a series of interface shear tests have been conducted to investigate the sand-steel interface behaviors under large-displacement and cyclic shear. Three types of particles (quartz sand, carbonate sand and steel bead) and two normal boundary conditions (constant normal load, CNL; constant normal stiffness, CNS) were used in these tests. To simulate the large displacement shear process for monotonic installed pile, the large-displacement shear is performed using monotonic shear method. It is found that under the large-displacement shear with CNL condition, the quartz sand and carbonate sand show different breakage degrees and modes. Obvious particle breakage changes both the particle gradation and sample densification, which are the main reasons for the increase of interface friction angle. While for the cyclic shear with CNS condition, the interface strength shows a quick degradation feature, which is mainly affected by the initial shape of particles. It is also found that the previous interface shear plays a key role in this kind of degradation. When the shear displacement is small, the degradation is promoted with only a small amount of sand breakage. But if the sand breakage is significant under the large-displacement shear, abundant broken fine particles fill into the void and make the sand sample much denser. So, the degradation trend of interface strength will be suppressed. It is suggested that the previous large-displacement shear process for displacement pile should be adequately considered in the design.

Model Experimental Research On Effects Of Properties Of Interface Between Piles And Sand On Bearing Behavior Of Uplift Piles In Sand

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Sand Grain Crushing and Interface Shearing During Displacement Pile Installation in Sand

Performance of laterally loaded H-piles in sand

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Model Test Study of Bearing Behavior of Small Prefabricated Piles in Soft Soil Area

STUDY ON SINGLE RIGID PILE GROUND IMPROVEMENT MODEL UNDER EMBANKMENT

Centrifuge Modeling of Monotonic and Cyclic Lateral Behavior of Monopiles in Sand

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Soil-pile interaction on an instrumented pile under cyclic axial loads in sand

Ultimate Soil Resistance of the Laterally Loaded Pile in Uniform Sand

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Effect of Cyclic Jacking on Sand-Pile Interface Shear Behaviour

Quantifying the Influence of Pile Diameter on the Load Transfer Curves of Laterally Loaded Monopile in Sand

Model tests comparing the behavior of pre-bored grouted planted piles and a wished-in-place concrete pile in dense sand

Model Tests on Ultimate Uplift Capacity of Piles under Excavation

Centrifugal Model Tests on Working Behavior of Composite Foundation Reinforced by Rigid Piles with Caps Under Embankment

Multi-scale study of load-bearing mechanism of uplift piles based on model tests and numerical simulations

Effect of Pile-Soil Relative Stiffness on Deformation Characteristics of the Laterally Loaded Pile