Abstract:We present the development of a single-photon detector and the connected read-out electronics. This `hybrid' detector is based on a vacuum tube, transmission photocathode, microchannel plate and a pixelated CMOS read-out anode encapsulating the analog and digital-front end electronics. This assembly will be capable of detecting up to $10^9$ photons per second with simultaneous measurement of position and time. The pixelated read-out anode used is based on the Timepix4 ASIC ($65~\mathrm{nm}$ CMOS technology) designed in the framework of the Medipix4 collaboration. This ASIC is an array of $512\times448$ pixels distributed on a $55~\mathrm{\mu m}$ square pitch, with a sensitive area of $\sim 7~\mathrm{cm}^2$. It features $50$-$70~\mathrm{e^{-}}$ equivalent noise charge, a maximum rate of $2.5~\mathrm{Ghits/s}$, and allows to time-stamp the leading-edge time and to measure the Time-over-Threshold (ToT) for each pixel. The pixel-cluster position combined with its ToT information will allow to reach $5$-$10~\mathrm{\mu m}$ position resolution. This information can also be used to correct for the leading-edge time-walk achieving a timing resolution of the order of $10~\mathrm{ps}$. The detector will be highly compact thanks to the encapsulated front-end electronics allowing local data processing and digitization. An FPGA-based data acquisition board, placed far from the detector, will receive the detector hits using $16$ electro-optical links operated at $10.24~\mathrm{Gbps}$. The data acquisition board will decode the information and store the relevant data in a server for offline analysis. These performance will allow significant advances in particle physics, life sciences, quantum optics or other emerging fields where the detection of single photons with excellent timing and position resolutions are simultaneously required.

A Single Photon Counting Detector Based on One-Dimensional Vernier Anode

Two-Dimensional Photon Counting Imaging Detector Based on A Vernier Position Sensitive Anode Readout

Decoding Algorithms of Single Photon Counting Imager Based on Two-Dimensional Vernier Anodes

Design of Vernier Anode Detector and Its Electronic Readout Circuit

Modeling the Encoding Structure and Spatial Resolution of Photon Counting Imagers with Vernier Anode Readout

Study Of Ultraviolet Photon Counting Detector With Delay-Line Anode

Decoding Algorithms for Improving the Imaging Performance of Vernier Anode Readout

A Two-Dimensional Position-Sensitive Microchannel Plate Detector Realized with Two Independent One-Dimensional Resistive Anodes

Note: A Two-Dimensional Position-Sensitive Micro-Channel Plate Detector with a Cross-Connected-pixels Resistive Anode and Integrated Spectroscopy Amplifiers

Ghosting Theoretical Model of Single Photon Counting Imagers with Vernier Anode

Development of a single-photon imaging detector with pixelated anode and integrated digital read-out

A Position-Sensitive Micro-Channel Plate Detector with A Parallel-Strip Resistive Anode and Integrated Charge-Sensitive Amplifiers

Near-Range Large Field-of-View Three-Dimensional Photon-Counting Imaging with a Single-Pixel Si-Avalanche Photodiode

Novel Electronic Readout System for Micro-Channel Plate Detector with Wedge and Strip Anode

Spectroscopy Detection and Imaging System Based on Line Array Single Photon Detectors

Image performance of photon-counting imaging detector with wedge-and-strip anode

Investigation on extreme ultraviolet photon-counting imaging detector with position-sensitive anode

A Single Photon Detector Readout Circuit Based on 0.18 Μm CMOS Technology.

First Experimental Evaluation of a High-Resolution Deep Silicon Photon-Counting Sensor

Experimental study on photon counting imaging system based on avalanche photodiode

A Photon-Counting X-ray Detector Using SiPM and FPGA-only MVT Digitizer