Abstract:Summary form only given. Because of higher hold-off voltage and higher current than power semiconductor such as GTO, MOSFET, PCSS, SOS etc., spark gap switches are generally used in the last output stage of high power modulator. But its recovery time is millisecond level, so it is prevented on the high rep-rate conditions. The gaseous recovery in a spark gap was investigated by using Two-pulses method with which the tested spark gap was broken down twice by two identical voltage pulses with a preset time interval in between. While the first breakdown is overvolted breakdown, the second breakdown happens usually at a voltage much lower than the first one. By comparing the two breakdown voltages the gaseous recovery as a function of the time interval between the two voltage pulses was obtained. There are two plateaus on the curve of the breakdown voltage recovery. The first plateau appears at the voltage of about the DC static breakdown and the second one appears when the gas is almost fully recovered. It was found that the shorter gaps at all nitrogen pressure tend to recover faster and the gaps with higher pressure also tend to recover faster. If more energy is deposited in the spark channel produced by the first breakdown, the gas insulation recovers slower. Both the first breakdown voltage and the second one obey Gaussian distribution. If the second breakdown happens at the point before the end of the first plateau on the curve of the breakdown voltage recovery, its mean square deviation of the breakdown voltage distribution will be smaller than that of the first breakdown. By taking photographs of the discharge in the spark gap, it was important to find that the spark channel produced by the second breakdown usually does not follow that by the first breakdown. The second spark channel is located with a distance of 0~3 mm from the first one. The longer is the time interval between the two voltage pulses, the larger is the distance.

Study of Discharging Characteristics of Hollow Cathode Surge Protective Gap

Experimental Investigation of Discharging Characteristics of Hollow Cathode Surge Protective Gap

Study on Gas Discharge Characteristics for Gap Type Surge Protective Device under Low Atmospheric Pressure

Research of Surge Protective Gap with Active-Energy-Coupling-Triggered Circuit

Multiple-Gap Spark Gap Switch

Investigation on the Characteristics of a Two Gap Capillary Discharge Based on Surface Flash over Ignition in Atmosphere

Effects of Electrode Materials and Gap Distance on Protective Characteristics of Gap SPD

Research of Discharge Characteristics about Spark Gap Type Arrester

Overvolted breakdown and recovery characteristic of spark gap switch

Study on Multichannel Discharge Characteristics of Multigap Gas Switch Gaps

Characteristics and Dispersity of A Two Gap Capillary Discharge Applied for Long Spark Gap Ignition in Air

Study on the Electron Emission Process of the Pseudospark During the Hollow Cathode Phase under Nanosecond Pulsed Voltage

Pulsed Nanosecond Breakdown Of A Hollow Cathode Discharge With Pseudospark Geometry

Response time of surge protective devices employing triggered spark gap technology

Study on the Characteristics of a Two Gap Capillary Discharge

Research on Impulse Discharge Characteristics of Parallel Gap

Study on the Performance Degradation of an Ejected-Plasma-Triggered SF<inf>6</inf> Gas Gap for 10-kV Smart Distribution Network

Discharge Characteristics and Detectability of Metal Particles on the Spacer Surface in Gas-Insulated Switchgears

Study on an atmospheric pressure glow discharge

Experimental Study of the Laser-Triggered Discharge for the Application in a Gap Switch

Study on the Performance Degradation of a Plasma Jet Gun for Triggering High Pressure SF6 Gap