Abstract:With dramatic reduction in sizes of microelectronic devices, the characteristic width and thickness of interconnects in large-scale integrated circuits have reached nanometer scale. Thermal fatigue damage of so small interconnects has attracted more and more attentions. In this work, thermal fatigue of Au interconnects, 35 nm thick and 0.1-5 μm wide, is investigated by applying various alternating current densities to generate cycling temperature and strain in them. A multi-probe measuring system is installed in a scanning electron microscope and a probe-type temperature sensor is for the first time introduced into the system for real-time measuring the temperatures on the pads of the tested interconnects. A one-dimensional heat conduction equation, which uses measured temperatures on the pads as boundary conditions and includes a term of heat dissipation through the interface between the interconnect and the oxidized silicon substrate, is proposed to calculate the time-resolved temperature distribution along the Au interconnects. The measured fatigue lifetimes are presented versus current density and thermal cyclic strain, and the results show that narrower Au lines are more reliable. The failure mechanism of those Au interconnects differs from what is observed in thick interconnects with relatively larger grain size. Topography change caused by localized plasticity on the less-constrained surfaces of the interconnects have not been observed. Instead, grain growing and reorienting due to local temperature varying appear, and grain boundary migration and mergence take place during high temperature fatigue in such thin and narrow interconnects. These results seem to reflect a strain-induced boundary migration mechanism, and the damage morphology also suggests that fatigue of the interconnects with decreased grain size and film thickness is controlled by diffusive mechanisms and interface properties rather than by dislocation glide. Open circuit eventually took place by melting at a region of severely damage cross-sectional area with the grain growing and reorienting.

The Effects of Alternating Current on Deformation and Failure of 60 Nm-Thick Nanocrystalline Cu Lines

Advanced Numerical Characterization of Mono-Crystalline Copper with Defects

Effect of High-Density Electric Current on the Microstructure and Fatigue Crack Initiation of Stainless Steel

1216 Nano-Scale Strength Analysis by EBSD and AFM Hybrid Method in Ultrafine-Grained Copper Processed by ECAP

Length scale dependent yield strength and fatigue behavior of nanocrystalline Cu thin films

Microstructural Modification of Metallic Thin Films Via High-Frequency Alternating Current Treatment at Room Temperature

Development of Multi-Scale Computation Framework to Investigate the Failure Behavior of the Materials

Influence of Strain Amplitude on Low-Cycle Fatigue Behaviors of a Fourth-Generation Ni-Based Single-Crystal Superalloy at 980 °C

Environmental effects on deformation mechanism and dislocation microstructure in fatigued copper single crystal

Delaying Effect of High-Density Electric Current on Fatigue Crack Growth in A6061-T6 Aluminum Alloy

Alternating-current induced thermal fatigue of gold interconnects with nanometer-scale thickness and width.

Simulation of Internal~ Stresses~ Near the Surface and Fatigue Crack Nucleation for A Copper Single Crystal in Cyclic Deformation Saturation Stage

Influence of thermal annealing on the microstructure evolution, fracture and fatigue behavior of nanocrystalline Cu films

Unusual Thermal Fatigue Behaviors in 60 Nm Thick Cu Interconnects

Low cycle fatigue behavior of precipitation-strengthened Cu-Cr-Zr contact wires

Cyclic Deformation and Fatigue Damage Behavior of Cu Monocrystals, Bicrystals and Tricrystals

Orientation Dependence of the Cyclic Deformation Behavior and the Role of Grain Boundaries in Fatigue Damage in Copper Crystals

Fracture Mechanisms and Mechanical Performance of Aluminum Conductor Alloy Reinforced Wires in High-Voltage Transmission Lines

Grain Boundary Effects on Plastic Deformation and Fracture Mechanisms in Cu Nanowires: Molecular Dynamics Simulations

Effect of Ag agglomeration-driven nanovoids formation on fatigue reliability of Cu–Ag alloy flexible interconnects

In situ high-cycle fatigue reveals the importance of grain boundary structure in nanocrystalline Cu-Zr