Abstract:This study explores the phenomenon of slip transmission across grain boundaries in coarse-grained copper. The associated effects on the deformation gradient are also investigated, using both experiment and simulation. An in-situ tensile test of a fully annealed copper specimen was conducted first using a scanning electron microscope (SEM). The deformation gradient and geometrically necessary dislocation (GND) maps at selected tensile strain values were obtained and characterized by electron backscatter diffraction (EBSD). In addition, a physically based strain gradient crystal plasticity finite element method model has been developed to simulate the early stage of tensile deformation behaviour of copper. In this model, slip transmission across the grain boundary is either allowed or blocked, depending on the alignment of adjacent grains. Slip transmission is allowed at grain boundaries between suitably aligned grains according to the Luster-Morris factor, residual Burgers vector is applied to consider the slip misalignment at GB region, and dislocation accumulation at grain boundaries is included following the Kocks-Mecking law. It was found that dislocation pile-up, lattice rotation and stress concentration were much higher near the impenetrable grain boundaries than at the penetrable ones. Due to the slip transmissions across grain boundaries, the stress and strain concentrations can be partially relaxed, and the slip transmission induced relaxation is associated with the number of active slip systems and shear strain on the best aligned slip systems. This study provides an effective strategy to investigate the early stage of plastic deformation, and a good agreement between experimental observations and simulation results has been achieved.

Simulation of Internal~ Stresses~ Near the Surface and Fatigue Crack Nucleation for A Copper Single Crystal in Cyclic Deformation Saturation Stage

Advanced Numerical Characterization of Mono-Crystalline Copper with Defects

Atomistic Numerical Investigation of Single-crystal Copper Nanowire with Surface Defects

1216 Nano-Scale Strength Analysis by EBSD and AFM Hybrid Method in Ultrafine-Grained Copper Processed by ECAP

An investigation of the combined size and rate effects on the mechanical responses of FCC metals

Microscopic Analysis by EBSD Method on Fatigue Crack Propagation Behaviour in Ultrafine-Grained Copper

Development of Multi-Scale Computation Framework to Investigate the Failure Behavior of the Materials

Dependence of hardening and saturation stress in persistent slip bands on strain amplitude during cyclic fatigue loading

The Effect Of Cu Orientation On Fracture Location In Cu3sn-Cu Interface Structure Under Monotonic Loading Condition By Molecular Dynamics Simulation

Multiaxial Behavior of Nanoporous Single Crystal Copper: a Molecular Dynamics Study

Analysis of Stress and Deformation States in Wedge Indented Face-Centered Cubic Single Crystals

Crystallographic analysis for fatigue small crack growth behaviors of a nickel-based single crystal by in situ SEM observation

A mesoscale investigation of strain rate effect on dynamic deformation of single-crystal copper

Fatigue crack propagation within Al-Cu-Mg single crystals based on crystal plasticity and XFEM combined with cohesive zone model

An investigation of slip transmission during uniaxial tensile deformation of a coarse-grained copper via EBSD characterization and crystal plasticity modelling

Extrusions and intrusions in the cyclic plastic zone of the growing fatigue crack in polycrystalline copper

Microstructure sensitivity of the low cycle fatigue crack initiation mechanisms for the Al 0.3 CoCrFeNi high entropy alloy: in-situ SEM study and crystal plasticity simulation

Prediction of Yield Surface of Single Crystal Copper from Discrete Dislocation Dynamics and Geometric Learning

Simulations of surface stress effects in nanoscale single crystals

In-situ SEM-EBSD investigation of the low-cycle fatigue deformation behavior of Inconel 718 at grain-scale

Fatigue Crack Growth on the Interface of Copper and Epoxy Molding Compound under Mixed-Mode Loading