Abstract:In a pH 5.66 acetate-acetic acid medium, the complex reaction of Al(II) with chlorophosphonazo-mS (MSCPA) is very sensitive. In order to react with Al(III) completely, MSCPA must be added excessively enough. Without doubt, the excess MSCPA in the reaction solution affected the measurement of light-absorption of the Al-MSCPA complex. Thus, ordinary spectrophotmetry is unfit for the measurement of such a complex. To eliminate such an interference, both A(537 nm), and A(618 nm) were selected as the work wavelengths and the spectral correction technique was applied to the characterization of the above complex. The result showed that the composition ratio of Al(III) to MSCPA is 1:1. Using the complexation, a new dual-wavelength approach named the light-absorption ratio variation approach (LARVA) was applied to the determination of trace amounts of Al(III), which often increases the sensitivity up to 10 times better than ordinary spectrophotometry. From the LARVA, the less the MSCPA added, the higher the sensitivity obtained. However, a too low amount of MSCPA caused an obvious error in the measurement because of the noise of instrument background. In the present work, 2.80 micromol x L(-1) MSCPA was added into the Al(III) solution. The absorbance ratio difference (deltaAr) of the Al-MSCPA solution is proportional to the Al(III) concentration in the range of 0 and 0.150 mg x mL(-1). The LOD of Al(III) is only 2 mg x L(-1). The result indicated that many kinds of metal ions did not affect the direct determination of Al(III). Besides, the addition of thiourea solution may mask Fe(III) and Cr(III) effectively. The complexation between Al(III) and MSCPA was completed in 2 min, and the color absorption of solution remained almost constant for more than 1 h. Therefore, a set of continuous flow analysis (CFA) device was designed for the online rapid analysis of Al(III) and coupled with LARVA to increase greatly the analytical efficiency. The results showed that the LOD of Al(III) is 6.5 mg x L(-1) and the analytical rate is about 30 samples per hour. This method has been applied satisfactorily to the determination of trace amounts of aluminum in two chemical reagents, giving recoveries in the range of 97.6%-103.5%.

Determination of Iron and Aluminum in Polycrystalline Silicon by Spectrophotometry

Determination of Trace Aluminum in High-purity Silicon with Chrome Azurol S Spectrophotometry by Nonlinear Fitting

[Determination of Fe, Al, Ca, Ti, P and Cu in Silicon Metal by XRF].

Simultaneous direct determination of aluminum, calcium and iron in silicon carbide and silicon nitride powders by slurry-sampling graphite furnace AAS

ICP-AES Method with Multicomponent Spectral Fitting Tests Silicon Element in High Silicious Content Alloys

[Assay of Three Kinds of Aluminum Fractions (al(a), Al(b) and Al(c)) in Polynuclear Aluminum Solutions by Al-Ferron Timed Spectrophotometry and Demarcation of Their Time Limits].

Determination of Aluminum with Dibromo-O-Nitrophenylfluorone by Primary-Secondary Wavelength Spectrophotometry

Determination of Trace Silicon in Nickel Sulfate Solution by Solvent Extraction

Reaction of Iron with Amorphous Silicon and Crystal Silicon for the Fabrication of Iron Silicides

Determination of the Optical Constants of Solar-Control Amorphous Silicon Thin Films on Float Glass

The Influence of Temperature on Silicon Colorimetric Determination in Plant Material

Study on the Effects of Different Ferron System, Ferron Solubility, Experimental Temperature and Other Factors for the Accurate Determination of Mononuclear Aluminum Concentration in Aqueous Solution

Determination of Al in fried flour food by modified chrome azurol S spectrophotometry

Determination of Trace Amounts of Aluminum by Light-Absorption Ratio Variation Combined with Continuous Flow Analysis

Volatilization and determination of monatomic silicon in industrial silicon

Determination of Chromium(ⅵ) and Aluminium in Food Simulates by Ultraviolet Spectrophotometry

Pouring and Curing for Sample Preparation Technology for the Analysis of the Silicon-Aluminum Ratio of Molecular Sieves by Energy Dispersive X-Ray Fluorescence (EDXRF)

Determination of Microamount of Silicon in Steel by Inductively Coupled Plasma-Atomic Emission Spectrometry

Calculating Models of Mass Action Concentration for Thermodynamic Properties of Phosphorus, Iron and Aluminum in Silicon Dilute Solutions

Determination of aluminum in drinking waters by a.c. oscillopolarography using solochrome violet RS

Determination of Aluminium in the Powder of Ni-Cr-Al-Y Alloy by EDTA Titrimetry