Experimental Research on Injection Molding Characteristics for Micro-Structure Plastic Parts

SONG Man-cang,ZHANG Chuan-zan,LIU Ying,LIU Jun-shan,LIU Chong
2010-01-01
Abstract:An injection mold in which microfluidic chip(a kind of micro-structure plastic part)can be molded is designed and manufactured.Using the single-factor experimental method,the influence of different process parameters(injection rate,mold temperature,injection pressure,holding pressure and time)on the incomplete duplication and sink mark of micro-structure plastic parts is discussed.The results show that injection rate and mold temperature are the principal factors in the incomplete duplication,and injection pressure is the secondary factor.The influence of holding pressure on the incomplete duplication is complicated,that is with the increasing of holding pressure,the degree of duplication reduces after the first increase.Mold temperature and holding pressure are two main influence factors on sink mark.Holding time has a negligible effect on the incomplete duplication,but it is the main reason for the warpage deformation.
What problem does this paper attempt to address?