Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Study on Processing Strategy of Complicated Doubly Curved Surface in Laser Forming

Study on processing strategy of singly curved surface based on plastic strain field in laser forming

Processing Strategy for Laser Forming of Complicated Singly Curved Shapes

Modeling and Process Planning for Curved Layer Fused Deposition

Process Modelling in Laser Forming of Doubly-Curved Sheets from Cylinder Shapes

Laser Forming of Doubly Curved Plates Using Minimum Energy Principle and Comprehensive Strain Control

A Study on Bending Direction of Sheet Metal in Laser Forming

Heating Position Planning in Laser Forming of Single Curved Shapes Based on Probability Convergence

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Process Planning for Laser Peen Forming of Complex Geometry: an Analytical-Based Inverse Study

The Forming Control Method of Multi-Track Laser Cladding on Curved Surface

Effect of different heating methods on deformation of metal plate under upsetting mechanism in laser forming

Processing-Scheme Design for Forming Curved Ship Plate and Analysis of Calculation Cases

FEM Realization of Laser Curve Bending Process

NUMERICAL INVESTIGATION OF STRAIGHT-LINE LASER FORMING UNDER THE TEMPERATURE GRADIENT MECHANISM

Dynamic Analysis on Laser Forming of Square Metal Sheet to Spherical Dome

Theoretical and Experimental Study on Laser Compound Forming of Plate

Investigation on the bending deformation of laser peen forming with a simplified eigenstrain-based finite element model

Simulation and experimental research on spherical dome by 3D laser forming of square sheet

Process and Development of Laser Forming

Research on the mechanisms of laser forming for the metal plate