Abstract:Mechanical equipment operation frequently results in noise generation, which can raise concerns regarding quality and safety. This study focuses on electric vibrators, essential electromechanical systems, with the goal of identifying the source and transfer path of noise. To achieve this objective, an acoustic camera positioning analysis was performed to approximate the distribution and characteristics of the noise. Building upon this foundation, a thorough evaluation of the transfer path and noise contribution was conducted. Subsequently, targeted noise suppression methods were implemented based on the properties of the noise. Primary noise sources were observed to be classified into wind turbulence and mechanical vibration based on operating conditions. Time-frequency analysis revealed the presence of low-frequency signals (around 50 Hz) and intermediate-frequency signals (around the resonant frequency), corresponding to wind-induced and mechanical response noise, respectively. Leveraging the characteristics of the noise and its transfer path, passive methods (Sound-absorbing rubber and Soundproof cotton) and active method (filtered-x least mean squares algorithm) were employed. The findings of this study contribute to a better understanding of noise mechanisms and provide insights for noise emission strategies.

Transfer Characteristics Model and Noise Sources Identification for Accelerated Vehicle Exterior Noise

Investigation of Noise Characteristics of Electric Vibrator Utilizing Acoustic Camera and Transfer Path Analysis

Application of Acoustic Transfer Vector Algorithm on Acoustic Radiation for Drive Axle of Automobile

Identification of Vehicle’s Interior Noise Source with Operational Transfer Path Analysis

Sensor configuration method for identifying vehicle interior noise sources

Decomposition of Moving Vehicle Noise with Dynamic Transfer Model and Acoustic Holograph

The Application of Sensitivity Method in Vehicle Dynamics Analysis

Contribution of Pass-by Noise Sources with Acoustic Holograph and Dynamic Transfer Path Model

Contribution Analysis of Bus Pass-by Noise Based on Dynamic Transfer Path Method

Research on optimization control of vehicle road noise performance

Acceleration Noise Model Based on Horizontal,Vertical and Lateral Acceleration

Decomposition and Visualization of Vehicle Noise Sources with Transfer Path Acoustical Holography

Interior Noise Analysis of a Non-load Type Body SUV

Identification of noise sources radiation based on 3D transfer path acoustics holography

Noise Emission Models of Electric Vehicles Considering Speed, Acceleration, and Motion State

Response Analysis of Interior Structure Noise in Lower Frequency Based on Structure-acoustic Coupling Model

THE STRUCTURAL VIBRATION ANALYSIS METHOD FOR VEHICLE'S NOISE FACTOR

Describing Road Booming Noise with a Hybrid Simulation Model Using a Time Segmentation of the Excitation Load Approach

Prediction and Optimization of Full-Vehicle Road Noise Based on Random Response Analysis

Coupled Analysis of Engine Noise and Interior Noise of an Automobile

Application of measurement technology of sound intensity in noise source identification of automotive interior noise