Abstract:Laser peen forming (LPF) is a purely mechanical forming method achieved through the use of laser energy to form complex shapes or to modify curvatures. It is flexible and independent of tool inaccuracies that result from wear and deflection. Its nonthermal process makes it possible to form without material degradation or even improve them by inducing compressive stress over the target surface. In the present study, a fully three-dimensional numerical model is developed to simulate the forming process of laser peen forming. The simulation procedure is composed of several steps mainly including the shock pressure prediction, the modal analysis, and the forming process calculation. System critical damping is introduced to prevent unnecessary long post-shock residual oscillations and to greatly decrease the solution time for simulation. The bending profiles and angles with different thicknesses are experimentally measured at different scanning lines and scanning velocities to understand the process and validate the numerical model. The calculated bending profiles and angles agree well with the trend of the measured results. But it is found that simulations with the Johnson-Cook model are more consistent, matching the experimental results for the thick sheet metal with a convex bending, while the elastic-perfectly-plastic model produces a better agreement even though with underestimated values for the thinner sheet metal with a concave bending. The reason for this phenomenon is discussed, combining the effects of strain rate and feature size. Both the simulation and the experiments show that a continuous decrease in bending angle from concave to convex is observed with increasing specimen thickness in general. Large bending distortion is easier to induce by generating a concave curvature with LPF, and the angle of bending distortion depends on the number of laser shocks. [DOI: 10.1115/1.4002585]

Experimental Study on Edge Effects in Laser Bending

Analysis and Control of Edge Effects in Laser Bending

Modeling and Reducing Edge Effects in Laser Bending

Controlling Edge Effects in Laser Bending

Edge effect reduction in laser bending of DP980 high-strength steel

Analysis of Varying Velocity on Edge Effects in Laser Bending

Edge Effects of Metal Plate in Laser Forming

Effects of Laser Scanning Strategy on Bending Behavior and Microstructure of DP980 Steel

Experimental study on laser bending of sheet metals

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal

Research on Bending Angels of Laser Peen Forming Without Confine Layer

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Numerical Study on Deformation Behaviors in Intersecting Rectilinear Laser Bending

Influence of laser beam process parameters on the bending ability of Ti-6Al-4V titanium alloy sheets

Numerical Study on the Influence of Temperature Field on Laser Bending of Sheet Metals

FEM Realization of Laser Curve Bending Process

Analyses of Effects of Process Parameters on Laser Bending of Stiffened Panels

Quantitative Evaluation of Specimen Geometry Effect on Bending Deformation of Laser Peen Forming

STUDY ON LASER BENDING OF TITANIUM ALLOYS SHEETS

Three-dimensional numerical simulation and experimental study of sheet metal bending by laser peen forming

A Study on Bending Direction of Sheet Metal in Laser Forming