Abstract:This paper establishes a transient equivalent circuit of cross‐line same‐phase successive grounding faults, and analyses the characteristics of zero‐sequence current. Then, a fault initiation criterion based on kurtosis theory and the Teager‐Kaiser energy operator (TKEO) is proposed. Finally, a method for faulty line detection based on cross‐correlation distance and transient energy is proposed and different fault conditions verify the effectiveness of proposed method. Currently, theoretical analysis of single‐phase grounding (SPG) faults in low‐current grounding systems has reached a high level of refinement, and the corresponding detection methods have matured. However, there is a significant lack of research on successive grounding (SG) faults, particularly in the area of detecting cross‐line same‐phase successive grounding (CSSG) faults in arc suppression coil grounding systems. To address these issues, a novel faulty line detection method based on transient characteristics of CSSG is proposed. Firstly, a transient equivalent circuit is established, and the characteristics of transient zero‐sequence current (ZSC) are theoretically analysed. Secondly, variational mode decomposition (VMD) is employed to extract low and high‐frequency information from intrinsic mode functions (IMFs). Subsequently, a fault initiation criterion based on kurtosis theory and the Teager‐Kaiser energy operator (TKEO) is proposed, which can accurately detect the occurrence time of secondary faults. Finally, a method for faulty line detection based on cross‐correlation distance (CCD) and transient energy (TE) is proposed. The results of PSCAD simulation under different conditions and field test affirm the accuracy of the analysis and the effectiveness of the proposed method.

Identification of the distribution network's grounding status based on frequency track method

Arc High Impedance Grounding Fault Detection for Resonant Grounding Distribution System Based on Directed Area in Characteristic Frequency Band

Fault Location Method in Resonant Grounded Networks Based on Distributed Modulation and Compensation Adjustment

Fault Feeder Detection Method Utilized Steady State and Transient Components Based on FFT Backstepping in Distribution Networks

A Ground Fault Section Location Method Based on Active Detection Approach for Non-Effectively Grounded DC Distribution Networks

Fault Location Method Based on Full Waveform Information for Distribution Networks

A novel ferroresonance recognition method based on the excitation characteristic of potential transformer

Faulted Feeder Identification Based on Active Adjustment of Arc Suppression Coil and Similarity Measure of Zero-Sequence Currents

Fault Handling and Localization Strategy Based on Waveform Characteristics Recognition with Coordination of Peterson Coil and Resistance Grounding Method

Research of neutral grounding modes for 20kV distribution network

An FTU-Based Method for Locating Single-Phase High-Impedance Faults Using Transient Zero-Sequence Admittance in Resonant Grounding Systems

Identification Method for Single-line-to-ground Faults with Line Break Based on Phasor Measurement in Distribution Networks

Faulted feeder identification and location for a single line-to-ground fault in ungrounded distribution system based on principal frequency component

A Novel Location Method for Grounding Electrode Line Fault Caused by Unipolar Fault of the HVDC Transmission System

Transient Features Analysis of Cross-Line Same-Phase Successive Ground Faults in Distribution Network

Faulty Feeder Detection for Single-Phase-to-Ground Fault in Distribution Networks Based on Transient Energy and Cosine Similarity

PSCAD Simulation Study on the Distribution Network Voltage Transformer Failure

An Active Voltage-Type Grounding Fault Protection Method for Medium-Voltage Distribution Networks with Neutral Point Voltage Flexible Regulation

Faulty Feeder Identification Based on Data Analysis and Similarity Comparison for Flexible Grounding System in Electric Distribution Networks

Faulty line detection for cross‐line same‐phase successive ground faults in distribution network based on transient characteristics

Identifying Single-Phase-to-Ground Fault Feeder in Neutral Noneffectively Grounded Distribution System Using Wavelet Transform