Abstract:In this paper, the width and depth of rectangular surface-breaking defects were successfully gauged using an all-optical laser-ultrasonic system. The finite element method was used to simulate propagating paths of defect-induced reflected and transmitted Rayleigh waves. It is observed that most Rayleigh waves with wavelengths less than the depth of the defect are reflected by the defect. A small part of the Rayleigh waves with wavelengths greater than the depth of the defect directly transmits through the bottom edge of the defect without acting on the left edge of the defect. Based on the simulation results, a three-step detection method of width and depth gauging of rectangular surface-breaking defects is proposed. In the first step, the pulsed laser and detection laser are irradiated on one side of the defect. In the second step, the sample is moved to a certain distance to ensure that both lasers reach the other side of the defect. In the third step, two lasers are irradiated on both sides of the defect. The width and depth of the defect are calculated according to the arrival time of the incident, reflected, and transmitted Rayleigh waves, as well as the movement distance of the sample. Experimental results are consistent with the reference-results measured by using a digital microscope. The proposed three-step detection method is proved to be feasible in simultaneous measurement of the width and depth of rectangular surface-breaking defects. Furthermore, it may be potentially useful for measuring other types of defect structures.

Complex Surface Automatic Measurement for Ultrasonic Inspection

Research on Ultrasonic Detection of Complex Surfaces

Automatic Sensitivity Compensation Technology on Ultrasonic Inspection of Curved Surface

Nondestructive Evaluation of Special Defects Based on Ultrasound Metasurface

Research of Integrated Ultrasonic Auto Detecting Method on Curved Surfaces

Probe’s Auto-alignment in Curved Components Ultrasonic Survey

Research on Ultrasonic Measurement of the Large Curved Surface Parts

Quantitative Detection of Surface Defect Using Laser-Generated Rayleigh Wave with Broadband Local Wavenumber Estimation

Research of surface reconstruction and path generation by ultrasonic inspection

The Free Surface Ultrasonic Measuring and Checking Robot Kinematics Analysis

A Study on Free Form Surface Digitization Based on Ultrasonic Distance Measurement

The technique for measurement path be controlled based on surface reverse and ultrasonic measurement

Research on Ultrasonic C-scan Technique for Large Unsymmetric Composite Component

Application of Reverse Engineering to Ultrasonic Nondestructive Testing of Surface Part

Ultrasonic Inspection Method of Sculptured Surface Based on Locating by Software

Study on Path Generation Method of Curved Surface Part for Ultrasonic Inspection

Digitalization of Unknown Free-Form Surface Based on Variable-Direction Point Laser Sensor

Measurement of Sub-Surface Microstructures Based on a Developed Ultrasonic Atomic Force Microscopy

Width and Depth Gauging of Rectangular Subsurface Defects Based on All-Optical Laser-Ultrasonic Technology

Laser-generated Surface Waves for Quantitative Detection of Inclined Surface Cracks Based on Finite Element Analysis

Numerical Study of Length and Angle Gauging for Subsurface-Inclined Cracks Based on Reflected Surface Waves with Laser Ultrasonic Technique