Abstract:A reliable non-destructive testing technique that enables effective detection and quantification of defects within safety-critical curved structures is highly demanded both in manufacture and service. Conventional Ultrasonic Testing (UT) methods usually adopt planar ultrasonic probes and it is preferable to adjust the probe axis direction perpendicular to the curved surface, because both the transmitting and receiving sensitivities in the probe axis direction are the highest. This paper proposes a new UT method using a hemispherical-omnidirectional ultrasonic probe. This probe has an omnidirectional directivity pattern and can cover curved surfaces with normal incident ultrasounds at different scan positions without the necessity of adjusting the probe attitude and position to follow the curved surface profiles. A surface reconstruction algorithm is firstly proposed to estimate curved surface profiles, which is based on a fast-imaging algorithm for ultra-wideband radar called the Shape Estimation Algorithm based on the Boundary scattering transform and Extraction of Directly scattered waves (SEABED). This method only uses surface reflection echoes, and thus can inspect curved structures without knowing the surface profiles a prior. Further, the Synthetic Aperture Focusing Technique (SAFT) is implemented to generate a focused image of internal defects by performing delay-and-sum beamforming on defect echoes based on the reconstructed surface profile. The proposed UT method is eventually experimentally verified on a curved plexiglass specimen with 29.4 mm surface curvature radius containing three ϕ 3.5 mm Side Drilled Holes (SDHs) at different depths. Results show that compared with the planar ultrasonic probe, the reconstructed surface profile via SEABED is much wider and accurate with a relative error ≤ 0.47%. All SDHs are not only clearly positioned with relative errors ≤ 7.43%, but also can be accurately quantified from the curvature radius of SDH indications in the SAFT images with relative errors ≤ 8.60%. This work proves that the UT method based on the hemispherical-omnidirectional ultrasonic probe can emerge as a promising technique to inspect curved structures with high efficiency and accuracy, which has great potential in practical applications.

Automatic Sensitivity Compensation Technology on Ultrasonic Inspection of Curved Surface

Research of Integrated Ultrasonic Auto Detecting Method on Curved Surfaces

Error Compensation Technology of Ultrasonic Test Robot

Research on Ultrasonic Detection of Complex Surfaces

Research on Ultrasonic Measurement of the Large Curved Surface Parts

Research on Ultrasonic C-scan Technique for Large Unsymmetric Composite Component

The technique for measurement path be controlled based on surface reverse and ultrasonic measurement

Probe’s Auto-alignment in Curved Components Ultrasonic Survey

Nondestructive Evaluation of Special Defects Based on Ultrasound Metasurface

Sensitivity compensation method in ultrasonic inspection for curved components with variable thickness

Research of Image Analyse Based on Multi Axis Ultrasonic - Dectect System

Study on Path Generation Method of Curved Surface Part for Ultrasonic Inspection

Research on Error Compensation of Multi-joint Ultrasonic Robot Based on Ontology

A New Optical Angle Measurement and Compensation

Research of Automatic Ultrasonic Test System for Round Bar Flaw

Research on Automatic Ultrasonic Waveform Tracking for Curved Surface Composite Parts with Variable Thickness

Ultrasonic inspection of curved structures with a hemispherical-omnidirectional ultrasonic probe via linear scan SAFT imaging

Automatic Waveforms Track Research on Ultrasonic Inspection of Curved Composite Surface

Analysis on Error Compensation of Curved-Surface Workpiece Ultrasonic Testing Robot

Robotic Ultrasonic Measurement of Residual Stress in Complex Curved Surface Components

Ultrasonic Probe Position and Orientation Planning for Curved Components with Variable Thickness Based on Ultrasonic Beam Analysis