Abstract:As to minimize size of the measurement system of large size and ultra-long focal length lens, two mirrors are used to change light path. In this case, installation error of the two mirrors added may be a large obstacle to accurate measurement of ultra-long focal length lens. For the sake of analyzing how installation error of two mirrors infect the angle of Moiré stripes on receiver, Moiré stripes are understood as parallel lines which composed of point light source with certain light-path vector. This approach proposed uses the calculation formula from mirror deflection angle to the reflector unit normal vector, and the matrix form of the law of reflection, to calculate the relationship matrix from vector of incident light to vector of exit light. Based on unit normal vector of two mirrors, incident light-path vector, exit light-path vector, and analytic geometry, equation of line on which image of point light source place can be presented, so we can get the angle of Moiré stripes on receiver and so is the angle error caused by installation error of the two mirrors added into light path. In addition, the angle error of Moiré stripes is calculated theoretically in 49 different situations of small mirrors deflection smaller than 1 degree. The results indicate that the installation error of the two mirrors should be taken into consideration. A new method by using autocollimator to adjust the installation error of the two mirrors is proposed, installation error of the two mirrors can be controlled to lower than 1" through this method. Moiré stripes angle error should be better than (10-4) order of magnitude in this situation. Experimental results show that Moiré stripes angle measurement error is 0.005 degree, which fully illustrates the effect of mirrors adjustment when this system is used for the measurement of ultra-long focal length.

High-Accuracy Two-Dimensional Small-Angle Measurement Based On Laser Multiple-Reflection

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

A Systemic Model for Simultaneously Measuring Three dimensional Rotation Angles of the Linear Guide Track [J]

A Novel Method to Simultaneously Measure the Straightness

Study of the Method for Measuring Four-Degree-of-Freedom Geometric Errors of a Linear Stage

A High-Precision Five-Degree-Of-Freedom Measurement System Based on Laser Collimator and Interferometry Techniques

Research on high-speed and non-contact angle detection based on laser measurement

A Straightness Measurement System Using a Single-Mode Fiber-Coupled Laser Module

Small angle measurement method based on the total internal multi-reflection

Mathematic Model of Simultaneously Measuring Six-dimensional Parameters by Laser

Four Degree-Of-Freedom Geometric Error Measurement System with Common-Path Compensation for Laser Beam Drift

Development of Equipment for Simultaneously Measuring Two-dimensional Rotation Angles of the Linear Guide Track

A Three-dimension High-Precision and Non-contact Dynamic Angular Displacement Measurement System based on Heterodyne Interference

High Accuracy Calibration Method for Multi-Line Structured Light Three-Dimensional Scanning Measurement System Based on Grating Diffraction.

Analysis on mirrors installation error of high-accuracy long focal length measurement system

Simultaneous Measuring Method Of Linear Guide Geometric Errors In Four-Degrees Of Freedom

2D Micro-Angle Sensor Based on Laser Autocollimation

A compact 2D micro-angle sensor

Non-contact rotation angle measurement system for scanning mirrors

Design of a high-precision and non-contact dynamic angular displacement measurement with dual-Laser Doppler Vibrometers