Abstract:This article presents a fully differential high-dynamic-range direct-conversion receiver for sub-1-GHz band applications in a 180-nm CMOS technology. The integrated self-adaptive multipart automatic gain control (AGC) loops are designed to cope with large input signal. In the radio frequency (RF) domain, a gain-adjustable noise-canceling balun low-noise amplifier (LNA) and a high-linearity RF variable gain amplifier (VGA) are co-designed to keep a steady differential output power for the mixer stage. In baseband (BB), a novel gain distribution method is proposed to protect BB circuits from saturation. To prove the concept, one of the most typical and strict application scenarios in the sub-1-GHz band, digital television (DTV) standard, is analyzed and chosen as the design target. The receiver achieves a noise figure (NF) of 3.6–4.6 dB in the ultrahigh-frequency (UHF) band. A wide gain tuning range of 128.8 dB is realized in this work, featuring fully integrated AGC loops. The programmable bandwidth of the low-pass filter (LPF) can be adjusted from 1 to 4 MHz, supporting 2-/6-/7-/8-MHz signal channels. The maximum in-band third-order input-referred intercept point (IIP3) is 10 dBm under the conversion gain of 0 dB. The receiver consumes 49.56 mA from a 1.8-V voltage supply and occupies an area of 3.56 mm2.

A 31mA CMOS wideband BD-II B2&B3 mode receiver with 55dB gain dynamic range

A C-Band Four-Channel Receiver with Current-Sharing and Large-Signal Multigated-Transistor Techniques in 65-Nm CMOS

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A 0.1-1.9Ghz 65nm CMOS Variable-Gain Mixer-First Receiver with DSA and Noise-Shaping TIA.

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

A 60dB gain and 4dB noise figure CMOS V-band receiver based on two-dimensional passive Gm-enhancement

A 3.1–4.8 GHz CMOS receiver for MB-OFDM UWB

A E-Band Receiver with 8.8db Noise Figure in 55-Nm CMOS

80dB dynamic range ∑δ modulator for low-IF GSM receivers

An 80dB Dynamic Range ∑△ Modulator for Low-IF GSM Receivers

A 49-dB DR wide locking range hybrid AGC for an ISM-band receiver in 0.18 um CMOS

An 80dB Dynamic Range ΣΔ Modulator for Low-IF GSM Receivers

Analysis and Design of a 0.9 V 1 GHz-BW 14.6 Dbm-Oip3 Broadband Receiver with Current-Mode Analog Baseband in 12 Nm FinFET CMOS

A 3V 5.88mW 13b 400kHz Sigma-Delta Modulator with 84dB Dynamic Range

A Low Noise, High Linearity CMOS Receiver for 802. 11b WLAN Applications

A 0.9V 1.2GHz-BW 15.8dBm-OIP3 Current Mode Analog Baseband for Broadband Receivers in 12nm FinFET CMOS.

A Monolithic CMOS L Band DAB Receiver