Abstract:A wideband low-noise amplifier (LNA) with low and flat noise figure (NF) is presented in this article. For conventional wideband noise matching, the noise performance in the high-frequency region of the entire wideband is usually deteriorated due to the frequency-dependent nature of the minimum noise figure (NFmin) for a MOSFET. To address this issue, a novel wideband noise matching approach aiming at noise matching in high band is proposed. This approach can reduce the NF in high band at the cost of a slight NF increase in low band, eventually achieving a low and flat NF and thus a better overall noise performance for a wideband LNA. In addition, the multistage noise matching technique is employed at high frequencies to further reduce the NF caused by the second amplification stage. To validate the proposed techniques, a two-stage LNA prototype was designed and fabricated using a 65 nm CMOS process. The experimental results indicate a peak gain of 16.6 dB with a −3 dB bandwidth (BW) from 7.2 to 27.3 GHz (a fractional BW of 116%). Within the entire band of interest, the simulated NF is low and almost constant (3.3–3.4 dB), while the measured NF falls within the range of 3.30–3.72 dB. Considering the uncertainty of NF measurement, a 0.21 dB NF flatness is one of the best results among the reported millimeter-wave wideband LNAs. The measured third-order input intercept point (IIP3) is −6 dBm at 20 GHz, while the power consumption is 13.2 mW. In addition, only two passive transformers are used in this design, leading to a compact chip core area (0.14 mm2).

45-Nm Planar Bulk-Cmos 23-Ghz Lnas With High-Q Above-Ic Inductors

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 28 GHz LNA using defected ground structure for 5G application

A Highly Linear 2.4GHz Low Noise Amplifier

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A Cmos Multi-Band Low Noise Amplifier Using High-Q Active Inductors

A 37-to-41.8 GHz Double-Gm-Boosting LNA with 2.9-Db NFmin Using Quadruple-Coupling Transformer for Phased-Array Transceivers.

A 60ghz LNA with 4.7db NF and 18db Gain Using Interstage Impedance Matching Technique in 90nm CMOS

Inductorless CMOS Low Noise Amplifier for Multiband Application in 0.1–1.2 GHz

A 0.03-3Ghz Inductorless Wideband Low Noise Amplifier in 65nm CMOS

A 0.9/1.8/2.4Ghz-Reconfigurable LNA with Inductor and Capacitor Tuning for IoT Application in 65nm CMOS

Wideband Inductorless Low-Power LNAs with Gm Enhancement and Noise-Cancellation.

A 22-32.7 GHz Linearized LNA in 65-nm CMOS Using Multigate Transistor Technique

28 GHz Compact LNAs with 1.9 Db NF Using Folded Three-Coil Transformer and Dual-Feedforward Techniques in 65nm CMOS

A dual band CMOS two-stage variable gain low noise amplifier

A 0.1–3.5-Ghz Inductorless Noise-Canceling CMOS LNA with IIP3 Optimization Technique

A 26-40Ghz Transformer-coupled LNA with 3.1-3.7 Db Noise Figure in 22nm FD-SOI

A 7.2–27.3 GHz CMOS LNA With 3.51 ±0.21 dB Noise Figure Using Multistage Noise Matching Technique

A 22.9–38.2-Ghz Dual-Path Noise-Canceling LNA with 2.65–4.62-Db NF in 28-Nm CMOS

A Full Monolithic 26ghz LNA with Special Transmission Line and Transformer for 5G Applications in 55nm and 65nm CMOS