Abstract:This study proposes a broadband complementary metal-oxide semiconductor (CMOS) low-noise amplifier (LNA) with intrinsic band-selective out-of-band (OB) blocker rejection capabilities. The proposed LNA design utilizes a differential four-phase N-path filter as the amplifier load to offer a substantial total load impedance difference between the in-band (IB) and OB frequency bands. This ensures that the LNA design securely accomplishes a high-quality-factor frequency selectivity response with lower radio frequency signal losses and its OB rejection performance is maintained against process, voltage, and temperature variations, compared with the case of using the N-path filter as a signal path. To validate its blocker-tolerable performance, the designed LNA was fabricated using a 65-nm CMOS technology and was primarily characterized in the frequency division duplexing bands of the long-term evolution and fifth-generation new radio standards, spanning from 1.7 to 2.7 GHz. The implemented design consistently achieved a transmitter leakage rejection greater than 17 dB across all target frequency bands from several samples. Furthermore, the design attained IB voltage gains greater than 36.4 dB and 40.4 dB, noise figures (NFs) of 1.78 dB and 1.5 dB, OB input 1-dB compression point greater than –27.0 dBm and –26.7 dBm, and full-/half-duplexing OB input-referred third-order intercept points greater than 4.1/3.8 dBm and 4.8/5.0 dBm at the mid- and high-bands, respectively. The OB-induced NF degradation was maintained at less than 0.7 dB. A total bias current of 37.7 mA was required with a nominal supply voltage of 1.2 V. The occupied active area of the implemented design was approximately 0.77 mm2, excluding the bonding pads and input/output cells.

A Cmos Multi-Band Low Noise Amplifier Using High-Q Active Inductors

A 0.18um CMOS Using High-Q Active Inductors for Multi-band Low Noise Amplifier

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A Highly Linear 2.4GHz Low Noise Amplifier

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A BiCMOS Implementation of Noise Canceling Low Noise Amplifier for Wideband Applications

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

Ultralow Power E-Band Low-Noise Amplifier with Three-Stacked Current-Sharing Amplification Stages in 28-Nm CMOS

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

Inductorless CMOS Low Noise Amplifier for Multiband Application in 0.1–1.2 GHz

A CMOS 0.5&#x2013;10.6 GHz Inductor Feedback Low Noise Amplifier for Multi-Standard Application

Designs of CMOS Multi-band Voltage Controlled Oscillator Using Active Inductors

A dual band CMOS two-stage variable gain low noise amplifier

A 0.03-3Ghz Inductorless Wideband Low Noise Amplifier in 65nm CMOS

45-Nm Planar Bulk-Cmos 23-Ghz Lnas With High-Q Above-Ic Inductors

Blocker-Tolerant Broadband CMOS Low-Noise Amplifier Employing N-Path Filter-Based Load

A Wideband CMOS Inductorless Low Noise Amplifier Employing Noise Cancellation for Digital TV Tuner Applications

A 22.9–38.2-Ghz Dual-Path Noise-Canceling LNA with 2.65–4.62-Db NF in 28-Nm CMOS

Wideband Inductorless Low-Power LNAs with Gm Enhancement and Noise-Cancellation.

CMOS Wide Band Programmable Gain Low Noise Amplifier